Items Needed for Washing Windows

(All items except the Dawn were purchased at Dollar Tree)

Dawn Dish Detergent

Small Bowl or Bucket

Scrubby Pads

Absorbent Cloths

Squeegee

Steps

1. Place a few drops of Dawn in your container with a couple inches of water.

2. Dip the scrubby pad into the water and squeeze out.

3. Scrub the glass. The Dawn along with the scrubby gets the dirt off and does not leave a residue.

4. Squeegee the window, starting at the top and working down, wiping off the "blade" each time with a cloth.

5. Wipe around the edges to absorb any leftover water and dirt.

Who would have known this is all it takes to get professional results? Give it a try and see if you like the Washing Windows like The pros. http://chaoticallycreative.com/2012/03/16/wa...

#Bestof2012

We considered replacing the mirror altogether, but decided to go the less expensive route first and see how long it would buy us.

*Questions and unexpected events that arose during the project:

I didn't know how well the mirror was attached to the wall. I also didn't know how well my adhesive would adhere to the mirror and trim.

* Cost Comments:

1"x4" MDF (32 ft) - $20

1/2 birch plywd - $15

Trim (40 ft) - $20

Crown (3 ft) - $4.50

Lights - $60

*My motivation to do this project:

The mirror was large and an eye sore. We wanted something a little nicer.

*Project Steps:

The first step was to replace the single light fixture with matching twin ones. I ran the wiring, secured the boxes and mounted the new lights. This was required due to the shelving unit. I then measured out the surface and determined the size of the shelving unit. Then I purchased the materials and started designing as I cut. The shelving unit was assembled and attached first. It was ~2 inches higher than the mirror and secured to a stud to help support the mirror against the wall. The trim and molding was measured, cut and secured using GOOP adhesive and tape to hold in place until it was dry.

Advice:

Don't assume the mirror is attached to the wall well enough to hold the additional weight. Make sure it is supported fully.

Do measure twice and cut once.

Materials:

Wood, MDF, Trim - $0.00

Light fixtures - $0.00

I'm thinking of moving some of the roses to a new bed and putting in the Russian sage...or {gasp!} removing them and selling them to another gardener. For some reason I've never been very good with roses. It's the only plant that's never seemed to like my style of green thumb ;-)

Would appreciate any help....especially if you're in a similar zone :-) Thanks!

Overall, we're thrilled with the results and learnt a lot in the process! Here's the link to the full reveal: http://livingbeautifullydiy.blogspot.ca/2011...

We hope this inspires you!

Melissa and Ian

www.livingbeautifullydiy.blogspot.com