Shower framing, noise and moisture.
by
Del Taylor
In the process of adding a full bath to the master bedroom. I purchased a 48-inch shower surround which included the shower pan; this cost a bit more than mid-range quality. The manufacturer instructions say that this product needs to be attached directly to the wall studs. I do have the exact framing required in place and ready. Now I question, the back wall has shared framing to another bedroom, what will the noise level be by someone showering in the new bath, for that adjacent bedroom? Also, by installing the shower directly to the wall studs, with glue and parameter screws, will there be a moisture problem? Any suggestions at this point would be greatly appreciated! Thank you.
Related Discussions
Suggested Project Book
You will need to add sound deadening insulation to this wall before installing the shower or the noise will be very evident in the other bedroom. As for the moisture problem, there shouldn't be any if you only use screws on the shower flange because these will be covered up by your trim.
We ALWAYS use a cement board as a backing to any shower install. When water makes its way back to the sub (and someday it will), you have protection.