How do I clean grout between ceramic tiles in the bathroom?

Web27860184
by Web27860184
  9 answers
  • Janet Panos Janet Panos on Aug 13, 2017

    Of course it depends on how dirty the grout. However, if the grout just needs some spiffing up in a few areas, Clorox puts out a tile and grout pen called Tilex that worked well for me. if it is a large area, use a combination of vinegar and baking soda and a little elbow grease with a toothbrush -- that should do the trick!

  • Kim Kim on Aug 13, 2017

    I use Commercial Soft Scrub w/bleach And a green pad.

    : )

  • Landsharkinnc Landsharkinnc on Aug 13, 2017

    if it's moldy, a 'tub/grout' spray works pretty well -- may need more than one application if bad -follow directions --- stuff has bad fumes

  • Sal13090685 Sal13090685 on Aug 13, 2017

    I've tried a lot of different products and the best results are by using toilet bowl cleaner with bleach. With the easy pour spout, just follow the grout line, let it set a few minutes, scrub with a stiff brush and wipe up. You'll be surprised at the results.

  • Johnavallance82 Johnavallance82 on Aug 13, 2017

    With Bleach - You can also Paint them or re-Point them.

  • Cin21825342 Cin21825342 on Aug 13, 2017

    I use toilet bowl cleaner gel. Squirt it on the grout lines and wait 15-20 minutes before scrubbing off.

  • Tyree Bruce Tyree Bruce on Aug 13, 2017

    I spray peroxide/water on it, then make a paste of vinegar and baking soda and apply it to the cracks. SCRUB with toothbrush then rinse. IF you need something more heavy duty bleach is my bet

  • Susan K Mullins Susan K Mullins on Aug 13, 2017

    I used a paste made from Comet and water, scrub with a toothbrush. Rinse well. Repeat if needed.

  • Cleaning Grout with Hydrogen Peroxide, Baking Soda, and Dish Soap

    1. Make a paste.
    2. Apply the paste with a toothbrush.
    3. Let the mixture sit on the grout for 15 minutes.
    4. Rinse the grout with warm or hot water to remove all of the solution.
    5. Use a rag to wipe the grout to remove any leftover residue or dirt.

    Mop the floor with clean water.


    OR


    Making a paste with OxyClean and water. Apply let sit for 20 mins. Scrub with toothbrush. Rinse well.


    Once it's clean, SEAL!