How do I fix a hole in my lathe and plaster wall?
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to trap fruit flies?
Does anyone know how to get rid of fruit flies with a homemade trap?
How to remove popcorn ceiling with vacuum?
Is there a way to use a vacuum to remove a popcorn ceiling?
How to fix a crack in a door frame?
How to fix a door frame with a split in it?
How do I fix these lathe and plaster walls?
The problem exist in 1 corner of the kitchen and bathroom.Neither room has an exhaust fan in them.Moisture has been the issue.The house in Utah was built in 1919.
Do I need to the find studs in a lathe & plaster wall when installing bead board paneling?
I'm using liquid nails and a nail gun to install.
Hi there, I've found that plaster can be fixed just like a hole in drywall. Create a "patch" to completely cover the hole (I like fiberglass sheet rock tape for this) and then cover it with plaster/joint compound, allow to dry and keep adding until you completely cover it. From there it would be some experimenting to create the exact texture of your plaster.
https://www.thisoldhouse.com/how-to/how-to-repair-plaster
I have also used thin drywall to stabilize a hole, and then plastered over it, and the patch is still good 30 years later.