Repurposed Industrial Metal Stand Party Table

by GadgetSponge Design House

Found, industrial metal base turned party table!

table industrial repurpose rustic, painted furniture, patio, porches, repurposing upcycling

It all started with the factory base that a friend found curbside. I sanded it down a good bit to know some rust off and to bring back some metal sheen.

I took some scrap treated lumber that I had left from another project and cut it to fit the top. I then torched it to bring out the grain of the wood more.

As you can see, I also had to make three custom foot pads because three legs were shorter than the fourth.

In the center of each side, I mounted a bottle opener to keep the party rolling.

I've got lot of yardsticks so I used four (stacked two high to fit the height) in the center to give it some more character.

The top wood was bolts on with inset holes to bring on more of the industrial look.

Finally I clearcoat the whole piece a few times so it would survive any weather that might strike a good party. This piece is built to last!

Measurements: 23" tall; 23" wide; 26" deep.

Enjoyed the project?

You can do it! Saved to your projects

Frequently asked questions

Have a question about this project?

Ask a Question

Comments

Join the conversation

4 comments

Hannah V on Jul 18, 2014
Very cool and rustic.

1 Reply
- GadgetSponge Design House on Jul 18, 2014
  @Hannah V Thanks so much Hannah!
  
  Like
Unique Creations By Anita on Aug 17, 2016
Very cool, great idea.

1 Reply
- GadgetSponge Design House on Aug 17, 2016
  Many thanks!!
  
  Like