walnut from the neighbor's barn that was torn down. Using only a circular saw and a Kreg Jig, we finished the table in record time. We cut off the ends of the table for the legs at 15" tall, leaving 50" for the top. We measured the width and used scrap furring strips for cleats on the legs, then nailed walnut planks into the cleats. With a quick trim piece of walnut on the lip of the shelf, we were done! Our only cost was in screws and nails. Since then we've found several discarded doors on the curb in our town, and have built door tables for friends! For step-by-step instructions visit my post: http://www.killerbdesigns.com/reclaimed-door...