Scratches in stainless steel sink

How can I remove light scratches on stainless steel sinks?
  23 answers
  • Michele Michele on Oct 08, 2016
    Try a clean cloth and some WD 40. Spray the WD40 onto the stainless steel and rub until it shines! This will minimize the look of the scratch.
  • Sherry Davis Sherry Davis on Oct 08, 2016
    Also try soft scrub.
  • Denny S Denny S on Oct 08, 2016
    200 grit wet/dry metal sandpaper or finer, really depends on how scratched it is. basically like car body repair
  • Iris Iris on Oct 08, 2016
    Go to Home Depot or Lowe's or whatever store that carries sandpaper and buy a sponge sanding pad. This will be a sponge material covered in very fine emery, buy the finest grade available. Sand your sink, going with the grain. There will be several different grain directions. Use Comet or something like The Perfect Sink polish product. This is easy, takes less effort than you might expect, and you will be amazed at the results.
  • Ros8818432 Ros8818432 on Oct 08, 2016
    BAR KEEPERS FRIEND OR BON AMI CLEANSER WITH A GREEN SCRUBBY, STEEL WOOL GOOD LUCK
  • Arnie White Arnie White on Oct 08, 2016
    I restore our stainless sink to like new condition using comet cleanser and a scouring sponge. The technique I use is to add enough water to create a watery paste and scour using long strokes and a lot of elbow grease that follow the existing "grain" of the stainless. Deeper gouges can be dressed out using 80 and 120 grit sand paper, again being careful to use the existing grain as your guide followed up with the scouring sponge for a uniform look. I have also used my detail sander but swirl marks will need to be hand sanded out afterward. Finally, rinse thoroughly with water, towel dry. I cap the job with a light spritz of stainless steel spray which is sold everywhere.
  • Jay Nemeth Jay Nemeth on Oct 08, 2016
    Rubbing compound works well
  • Wayne Alan Wayne Alan on Oct 08, 2016
    If they are very light, then using soft scrub, a sponge and a hook attachment for your drill. Cut the sponge in a circle to match the round hook attachment. Apply some soft scrub and let the drill do the work.. If it is a deeper scratch, use a coarse abrasive like valve grinding compound then switch back to the soft scrub to get back the luster of the stainless steel. You can obtain the tool from most auto body supply stores such as Napa Auto Parts
  • Elaine Elaine on Oct 08, 2016
    We have very hard water and cleaning those stains and the scratches takes work. When the stainless steel is relatively clean, use cooking oil - Canola or olive or whatever you use - to mask what you couldn't remove and shine the steel. A little oil on a soft cloth rubbed onto the stainless steel makes it look like new.
  • Dexter Dexter on Oct 08, 2016
    Take a hand full of aluminum foil with some water and scrub it.
  • Kara Kara on Oct 08, 2016
    Use Barkeeper's Friend. Even if it doesn't get out the scratches, your sink will shine like new.
  • Alton Alton on Oct 08, 2016
    We have used steel wool for light scratches
  • Nancy Engler Ulicny Nancy Engler Ulicny on Oct 08, 2016
    Tried several of the solutions offered, used the wet foil wrap and it worked very well. All the solutions offered were great.
  • Marie Vanhuis Marie Vanhuis on Oct 09, 2016
    baking soda and vinegar paste
  • Erin Maloney Erin Maloney on Oct 09, 2016
    I agree, Bar Keepers Friend! Scrub with the "grain" of the stainless and it will look like new!
  • Alice Mike Bischoff Alice Mike Bischoff on Oct 09, 2016
    Try stainless steel scratch eraser appliance cleaner kit I used it on a really old sink and it worked
  • Grace Thayer Grace Thayer on Oct 11, 2016
    I use Bar Keepers Friend cleanser and polish. You can find it on Amazon for around $7.
  • Elaine Kater Elaine Kater on Oct 12, 2016
    Again Zud, can be found at Ace Hardware. Also works GREAT on stains on Corning Ware
  • Elizabeth Elizabeth on Oct 12, 2016
    Bar keepers friend then I use car wax and polish the sink. Looks really great when all done!
  • Sonia Burrows Sonia Burrows on Oct 14, 2016
    I tried some of these on my stainless steel stove...the wet aluminum foil didn't do anything and neither did the Comet cleanser. The range is only two months old and my hubbie decided to drag the pot across the front of the range and scratched it. Will try bar keepers friend next.