This was one of my most exciting projects I have worked on. With the little experience I have, I love concrete work. I will give you all the steps I took to create this awesome fire bowl.
The bowls I use I'm not sure where you can get them. I snagged these from my office after a lunch part. They are plastic catering bowls. I believe any bowls could work.
Time: 3 HoursCost: $35Difficulty: Easy
Here is the list of products I used.
- Gel Fuel for the fire http://amzn.to/2afTY80
- Black Marbles http://amzn.to/2asn04K
Instead of Marbles you can use this Fire Glass Onyx Black http://amzn.to/2aeRxXN
-Sakrete high strength concrete mix
- 2 bowls of your choice ( the bowls I used were 12inchs for the large bowls and 10 inches)
- Constructions wire mesh
Tools & Miscellaneous Items Used
- Hand shovel
- Rubber Mallet
- Palm Sander aka Sheet Sander
- Sandpaper 80 grit and 220 grit
- Any oil should work (I used motor oil)
- Weights or large rock (hold bowl in place)
- Tin Snips http://amzn.to/2anyNk9
1. I would recommend using a separate mixing bowl. I used the same large bowl, but the scratched from the shovel transferred to the form.
2. Add concrete mix into a bowl and add water. Be sure to mix the to concrete well. Do not over water it.
3. Next, you can oil your large bowl, to provide an easier release.
4. Add concrete to the large bowl. Then sit the smaller bowl in the form and press down. You'll want to do this so you can see how much concrete you will actually need. Once you find how much you need, you should clean the smaller bow. Dry it off and oil it up.
5. Place the smaller bowl in the concrete then place weights on top. Anything will work that is heavy enough to prevent the bowl from rising.
6. Vibrate the bow using a sander and a mallet. The goal is to get the bubbles to rise to the top and escape the form.
The top edge was a bit rough. To clean get it up sanded it down using sandpaper.
80 grit to knock it down some and 220 grit to smooth it. The higher in grits you go with smoother it will be.
To support the rocks or in my case the marbles. I used some construction wire mesh.
I shaped the mesh to sit in the bowl. The mesh can be found at your local hardware store. I use tin snips to cut the mesh down to size, and my hands to shape it.
Once you cut this stuff it can be very sharp. So be sure to bend it over and to make it safe for handling.
I am using Gel Fuel for the fire http://amzn.to/2afTY80
This one last about 6 hours of burning time. I usually just smother it to kill the fire for reuse.
1. Remove the lid from the can, then sit the can in the bowl.
2. Add the mesh
3. Add the rocks/ marbles (leave the center open) the fire needs to breathe.
4. LIGHT IT UP!!!!
If you find this helpful be sure to stop by my youtube channel and subscribe for more home and shop projects.
Check out the video for more information.
Add Me Here
Suggested materials for this project:
- Gel Fuel (http://amzn.to/2afTY80)
- Black Marbles (http://amzn.to/2asn04K)
- Concrete mix (Local Hardware)
Have a question about this project?Ask a Question
23 Questions on This ProjectSee All