i have a Keep Rite gas furnace with an exhaust small exhaust fan. does anyone know if it should run constantly or only when the burner turns on for heat?
hi i have 2 aluminum maglite flashlights i cannot remove the bottom ends to change batteries they are locked solid any suggestions i thank you in advan... See more
I'm trying to replace the existing old-school thermostat with a Nest, but there are only two wires between the air-handling unit (SpacePak ESP-3642D) and the thermost... See more
Hi, I have around 9 ceiling lights and one of them suddenly stopped working.I thought it might be the bulb issue and changed the bulb, but after changing as well the ... See more
Broken light bulbs in sock can't remove
We bought a house and the gas heating and air was installed over our living room. Needless to say it rattles and sounds like a helicopter over head. They installed it... See more
How to install a light bulb in resest light holagen
My ac unit is blowing outside but no air is coming inside it had ice on it but I turned it off for 24 hours and melted off but there is still no air coming inside the... See more
Hi, I have a reasonably sized kitchen which is in an extension to a 350 year old cute thatched cottage in the UK.However, in it there are loads of 1980's horrid spotl... See more
I live in an area where TV reception is sporadic and outdoor reception is not a possibility Cable is expensive, and previously purchased indoor antennas do not work ... See more
We notice it when there is frost on the roof
Smoke detectors still chirping after I change the battery. I end up pulling out the battery hollder. Whats going on?
What is causing two separate pairs of fluorescent bulbs in separate fixtures in one ceiling mount to be dim. Changing the bulbs has not resolved the issue. I have n... See more
Recently parked under a pine tree and sap dropped on the hood in a few places. Like a fool, I used "Goo Gone" to remove the sap; well, it also removed the finish fro... See more
Our square lampshade had a bad day a while back. Can't find a new one that matches this one and I have really gotten used to the square shade. If this had 'ribs' in i... See more
The lampshade shredded! The frame is good, how do I recover it and what do I use??? It is a formal lamp.
I replaced a single light bar with two separate light bars in the master bath. Now I have an ugly plastic cover over the junction box which cannot be hidden with a dr... See more
The home we just purchased has a large fluorescent light fixture in the middle of the kitchen ceiling what can I do to replace
So my bedroom light switch stopped working. I thought the old switch had just died, so I switched it with another switch from another room. It seemed to do the trick.... See more
I have a chandelier I want to hang where there is no ceiling mount. How can I extend the cord and add a plug?
Do I have to rewire the whole thing? Would it be as easy as rewiring a lamp? It has 12 bulbs.
I plan to retrofit cans or replace incandescent bulbs in my 25 recessed light fixtures throughout the house.
This is for two reasons: first, because of the cost of running incandescent and second, because of the air migration through non-airtight (and non-IC-rated) existing ... See more