Mim Gottschalk
Mim Gottschalk
  • Hometalker
  • Medford, OR
Asked on Oct 16, 2017

What's the best way to paint a shower that's most likely fiberglass?

Hillela G.

Answered

It was painted before we bought the house and is chipping off, showing the "marbelized" surface beneath. Any suggestions for refurbishing the surface are welcome. Thanks!

Mim in Medford, OR

1 answer
  • Hillela G.
    on Oct 17, 2017

    . Preparation is the key here and if steps are skipped, the quality of the end result will be substandard.
    Step 1. Sand the entire area to be painted with 320 grit Sandpaper [linked by editor to product info at Rockler], you don't want to sand through the gel coat you simply want to sand until it hazes over and the finish becomes dull.
    Step 2. Clean the shower with Muriatic Acid [linked by editor to product info at Amazon] to remove all of the dust. Then rinse the entire thing with water and let dry completely.
    Step 3. Painting. Use a good quality primer first then use a good epoxy based paint in the color of your choice. Rustoleum makes an appliance paint [Rustoleum "appliance paint"] which works perfect for this application.. The only draw back is the only colors are white and almond. I have used oil based paints before as well with a satisfactory result, you simply have to watch close for runs in your paint. Always use a spray gun or spray can, never brush or roll paint on.
    That's it, its really that simple and the results are usually stunning.
    Happy Painting
    • Mim Gottschalk
      on Oct 17, 2017

      Thanks so much, Hillela. Seems simple enough if I adjust my color choice to white or almond! Or go the oil route with extra vigilance. MG
Your comment...