I have outside wall porch lights that are rusted and stained. How do I clean and repaint those outside wall porch lights?
Think they are called Hollywood lights, so ugly.
Recently one morning I was running my blow dryer when all of a sudden it just stopped dead. (Some of you I am sure can relate to an overheated blow dryer and the fac... See more
But I'm not sure. We had a bunch of rain the last few days and there was some water seepage into my utility room. Yrs ago the same thing happened -- lots of rain and ... See more
We're off the grid at the cottage and were wondering if an electrician could change the wiring of ceiling fan with lights so that it could be plugged into the wall as... See more
I have a outdoor lighting system that uses MR16, E12 and E26 fittings - basically 2 pin, a small screw and a big screw.I've seen lots of flame bulbs out there, has an... See more
,Hello,over the last few months,the lights in the house have gradually switched off.Now,all the lights are off but all connections into the plug sockets are fine.Any ... See more
hard to pull with no start.
Checked the hardware stores and I can’t find it.
my golf cart gave me a click sound when I tried to start it. I checked the water in batteries, was good, charged it, then saw It had corroded battery terminals, I... See more
I have some knob and tube wiring in the basement. The kitchen is right above the area where the knob and tubing is and it is VERY cold. I know you can't cover up the ... See more
How can I safely install a combination switch/outlet so that the switch activates the outlet? I want to plug a lamp into the outlet and turn it off and on with the sw... See more
Have older house, remodeling in steps. Some areas have both k&t wire combined with new 12\2. Best way to trace to source, fuse panel? Some is buried in walls!
I have one outlet in my bathroom and would like to add another.can I somehow use the existing outlet and connect off it?
I’m a senior citizen grandma who loves working with wood. I’m comfortable with most power hand tools, but haven’t yet gotten the courage to try using a router y... See more
I can not get electricity to a wall where a lam NEEDS to be.
We used our microwave (Kenmore fr Sears) light and when it burned out, there were no replacements.? The store recommended ”to but a new one?” We aren’t doing th... See more
My cat knocked over my hurricane lamp and the top globe is broken, can't find a site that sells the top globe! Along with my lamp, my heart is broken too. Can someone... See more
This floor lamp has 3 parts to it & there's not a tight connectin when screwed together so it bends & tips over. Any suggestions? Thanks!
I cannot tell navy from black in my clothes closet. What is the brightest light you would recommend?