hi i have 2 aluminum maglite flashlights i cannot remove the bottom ends to change batteries they are locked solid any suggestions i thank you in advan... See more
Hi, I have around 9 ceiling lights and one of them suddenly stopped working.I thought it might be the bulb issue and changed the bulb, but after changing as well the ... See more
The wood to metal was burning at slow simmer second time this had happen same area
I clean the spark plug and turning the engine . What could be wrong????
I have an older one that looks fine except that it has stopped rotating. I hate to throw it away instead of repairing it.
People drywalled over paneling without pulling out outlets. I know hiring electrician is my best solution but finances... Any ideas to enhance appearance?
We need to convert our wood burning fireplace to gas logs or the electronic kind anyone have recommendations for who could do this and approximate costs?? thanks
There are 4 white glass shades that hang down over 4 bulbs. They're held in place by screws.Two of them are broken and I don't know how to replace them. I don't want ... See more
Recently parked under a pine tree and sap dropped on the hood in a few places. Like a fool, I used "Goo Gone" to remove the sap; well, it also removed the finish fro... See more
Where would I fine a new piece for my ceiling fan? The piece I'm referring to is on the blade, the piece that attaches the blade itself to the motor. Somehow it is b... See more
Hi,We're buying a new house with an "open concept" living room. The builder (in all his cheapness) didn't put in any floor outlets. The only electrical outlets are ... See more
We live in rental apartment that was completely gutted and redone abouy 7 years ago, and everything related to electricity was done from scratch. Since we moved in... See more
I am replacing the two overhead light fixtures in our kitchen from the older tubes to the T-8 type. I bought two new fixtures that come with ballast. They work off on... See more
How do you cover ugly lamp cords that have to run across a hardwood floor?
We are building a new home, and want to put in LED lighting in the whole house. I am asking here to find out where I should look for design specs as well as product ... See more
In my unfinished basement- I am running electrical wires from Junction Box for outlets. Later my electrician will finish the job. How many electrical outlets can I h... See more
Light switch in kitchen will not stay tight for long. The screw holes are too big. It was moved up a little several months ago and was OK for awhile. Now it is loose ... See more
We have an earth shelter and would like to add lighting. Our ceilings are span crete and we wonder if we dare to make holes to put can lights in? Or would that weaken... See more
A whole batch of lights and outlets in one area of the house won't work. Please tell me we don't need extensive wiring work!!!!
This is what I see every morning! (see photo) Yes, I could (and do) sweep it but with my back "out" on occasion it's hard to sweep them the full length of our walk...... See more
I have an entertainment center from ello furniture(now closed) which has a non funtional control board.
Can this be fixed without having a schematic drawing of wireing plans?
Viewed them on Holmes on Homes last week, not sure if it's a Canadian product or available in the US?