DIY Pallet Kissing Booth

by Desiree G

3 Materials

1 Hour

Easy

Pallets are so much fun to create DIY projects with and I really wanted a little kissing booth for pictures at Valentines Day and that could double as many things like a Hot Cocoa Bar for Christmas pictures and even a Lemonade Stand! This was a fairly easy project and I kept it rough as you will see in the building pictures. I didn't measure and cut the front pallet planks. I laid them all down and screwed the planks to the side rails of the pallet I pulled apart. The ends don't line up but that's how I wanted it. A rustic feel.

Screw the pallet planks to the side/under braces of a pallet. There are usually three in a pallet. I used the third one for the side rails and cut it in half.

These are going to hold the side walls.

I cut some pallet planks down to smaller lengths for the side walls.

Once I had the front all screwed to the pallet rails, it needed a top counter ledge. By holding the pallet up to the rails I was able to mark the section that needed cutting out so that the ledge would fit into place.

You can see in the picture how the ledge fits into place on the pallet stand.

This is what it looked like before I screwed the side wall on.

Using the shorter pallet pieces and the bottom rail that I cut in half, I screwed the side walls into place. I just screwed the front of the planks to the front polls.