I have a Porter-Cable Staple/Brad Nailer Compressor Kit (about 10 years old) that has recently started to skip or miss shooting the staple. There are plenty of staple... See more
I'm hanging a chandelier above my kitchen table, but have decided not to hard-wire it in due to the fact that we will be putting our house up for sale in the near fut... See more
hi i have 2 aluminum maglite flashlights i cannot remove the bottom ends to change batteries they are locked solid any suggestions i thank you in advan... See more
I have what seems to be a pair of wires for each bulb. Is it possible to wire it up to this dual gang dimmer switch?Edit: Tested the wires and the 2 red wires are liv... See more
I bought a new stereo system to go in the living room. Wife had a fit!!! Doesn't want cables and wires running all over the floor. (Don't blame her) So we have dec... See more
I have a touch lamp that stopped turning on when touched. One bulb did burn out, and I've replaced the bulb, but that didn't fix the problem. I've tried replacing all... See more
The wood to metal was burning at slow simmer second time this had happen same area
How do I fix this lamp switch. The button broke off my standing lamp. I have no way to turn it on now.
I had the idea of using half of a rather large globe as the lampshade on a floor lamp. How can I use it safely?
My outside GFI Will not work. I replaced it with a new one and it still won’t work what should I do?
The electrical plug is loose, and moving around when you plug things in.. How can I fix?
Hello all, Similar to this https://www.hometalk.com/34406068/q-installation-of-wifi-light-switches, I was installing another WiFi switch at my place. However this tim... See more
A new lightbulb, in track lighting, it didn’t get threaded correctly and I can’t get it out. I’ve tried tape to get a better grip and it didn’t work
I can not get electricity to a wall where a lam NEEDS to be.
Is it safe electrically to put a plastic grocery bag in a shredder to make it easier when emptying? I don't want to start a fire because it's plastic and plugged in?... See more
propane stove came with the house. I tried to find a way to adjust it but nothing.
Our existing kitchen has a painted backsplash. Now that we're adding tile, the outlets need to come out from the wall to be flush with the new tile. How can this be... See more
I am in the process of redoing a very 1980s era bathroom. I just painted the vanity, new tile, painted walls, all new fixtures. I am installing a new vanity faucet... See more
The only plug in my bathroom is in the light fixture over the sink and I cannot reach it. What can I do for a replacement?
The lampshade shredded! The frame is good, how do I recover it and what do I use??? It is a formal lamp.
While trying to remove our burnt out light bulb in our yard light fixture, the bulb broke and is still in the socket. How do we remove this without getting cut?
I have an entertainment center from ello furniture(now closed) which has a non funtional control board.
Can this be fixed without having a schematic drawing of wireing plans?
I plan to retrofit cans or replace incandescent bulbs in my 25 recessed light fixtures throughout the house.
This is for two reasons: first, because of the cost of running incandescent and second, because of the air migration through non-airtight (and non-IC-rated) existing ... See more