How to hang a towel rod
Related Discussions
I'm trying to hang a curtain rod over a sliding glass door, but keep hitting something that I can't drill through.
The house is built of cement blocks, but there is drywall on the walls. I had another house that was the same type, but never had a problem with hanging curtain rods.... See more
How do I hang curtain rods if I can't find wall studs?
How do I hang curtain rods on drywall?
How do I hang curtain rods on drywall without them pulling out as soon as I put drapes on them?
Hang a paper towel holder under a cabinet without drilling holes?
Rental apt, cabinets are hard finished formica/plastic.
How can I safely remove a photo that's stuck to the glass in a frame?
Occasionally I've had the problem of photos sticking to the glass inside frames. First, I'm not sure what's even causing it. I don't use any moisture when dusting the... See more
How can I make this hidden door more hidden and less hideous?
I have a hidden door though it doesn't look so hidden at the moment and I like the appeal of a hidden door. We do need to use the door, but not often. This is in a b... See more
How can we camouflage the siding in our add-on room?
We live in a mobile and have an add-on room where a covered patio used to be. Now it's part of our living space and we would like to cover or camouflage the exposed a... See more
Typically they have a piece that you mount to the wall and then when you put the rod on, these mounts go inside the ends of the towel rod.
If this doesn't help, try Googling the brand of towel rod you have. Assuming you don't have the instructions.
Hold towel bar up on the wall where you want it (with a level on top to make sure it’s level) and trace lightly around “feet” with pencil.
On the “feet” (part that goes against the wall) there is a little set screw. Loosen the set screws and remove the mounting plates.
Mount the plates where you traced the “feet” using toggle bolts unless you are over a stud, then use provided screws.
Toggle bolts are installed by drilling a hole through drywall using the size drill bit specified for the size toggle bolt you are using. (It’s on the package). Slide the toggle behind the drywall and tighten. I prefer to use toggles with wireties and caps (called toggler snap toggles) to hold them in place so that you are not juggling with all the parts of what you are hanging at once. They are available at your local home-improvement store.
I hope that all made sense
😊
https://www.youtube.com/watch?v=nh7xpJNJD5Y
You got this-https://www.youtube.com/watch?v=9NZS0v9kP-g