How do you kill roots from a tree stump?

  6 answers
  • Sunshine Sunshine on May 23, 2018

    Cut several strips into the trunk with a saw. I did this to one of mine and it started to die after a while, then I dug it up.

    • Eroque022810 Eroque022810 on May 24, 2018

      Sunshine, did you add salt or anything else? And about how many years did it take? I have same issue and have never thought to ask, go figure. Would appreciate any help.

  • Sunshine Sunshine on May 24, 2018

    I didn't add anything. It took approximately a year and I was able to dig it up. Hope this helps.


  • Chloe Crabtree Chloe Crabtree on Sep 06, 2023

    Use this product and you should have success. Bonide

  • Chloe Crabtree Chloe Crabtree on Nov 07, 2023

    Begin by gathering a few supplies: a drill with a large bit or an ax, Epsom salt, water, wax, a tarp, and a shovel. Proceed to drill several 1-inch-wide holes in the stump's surface, including its aerial roots, ensuring each hole is placed at a distance of at least three to four inches. While six holes are sufficient, bigger stumps may require more. Ensure you drill down to around eight inches to allow for deeper salt penetration. Alternatively, you may use an ax to make hollows in the tree stump. Next, directly pour Epsom salt ¾ of the way up in the drilled holes and fill the rest with water to keep the salt moist. Then, plug the holes with wax. Additionally, cover the trunk remnant with a non-porous tarp to minimize rain and sun exposure so that the roots do not sprout again and the salt does its job of rotting the stump. Repeat the procedure every three weeks until the stump is dead, and dig it out using a shovel.


    If you don't wish to strain yourself by drilling holes, you can use the soaking method to remove a tree stump. In a bucket, combine Epsom salt and water in a 1:2 ratio. Generally, soaking a single tree base requires two gallons of water and one gallon of salt. Pour this solution all over the tree stump and its largest exposed roots. After drenching the stump, cover it with an opaque tarp or a plastic sheet, and add a layer of mulch on top to weigh it down. You can also sprinkle a nitrogen-rich fertilizer around the tree trunk's base to further boost its breakdown. Repeat this method at least once a week and chip away at the wood as it decomposes. Finally, pull out all the stump remnants, especially the root system, when it completely dries out. After disposing of the stump, you can repurpose the space by adding soil and sowing grass or flower seeds.

  • Deb K Deb K on Nov 11, 2023

    Hi Belinda, hope this helps. Drilling holes into the stump will help the hot water kill deep and exposed roots. After you're finished drilling, carefully pour boiling water over the stump, making sure to cover the entire stump. The hot water will shock the system and begin the decomposition process using heat.