Drill Driver or Hammer Drill which is best to use to hole into Briks ? I 'm trying to drill holes into walls so in need drill for it.can anybody suggest me best Drill... See more
I would like to purchase a power nailer. One where I don’t need a compressor. I’d like to spend less than $100 and I’d like it to accommodate small nails for li... See more
I'd like to start doing some basic wood-working. I have a 10" sliding miter saw, which is great for small cuts. But what would be the best saw to buy in order to do... See more
You said you had a bad experience from sanding without a mask. Could you give me any info in that so I can encourage my brother to use one
I am putting up a backsplash using a sheet of new corrugated metal. What is the best type of screw to use for attaching this to the studs on the wall? I need somethin... See more
I’ve cut granite before, as well as a lot of stained glass, but this time I want a Live Edge granite top. I own a 4” angle grinder with diamond blades, a full set... See more
Need help to unscrew this as you see in the picture . Thanks in advance.
Why do the loops pull off the sandpaper and stick to the hooks on the sander? This is a relatively new sander. I had new sandpaper on the unit and this was the second... See more
I have a Craftsman 3/8 inch 19.2 volt cordless drill model #973.113400. This battery # is 1301341 and is no longer being made. I have looked on the internet and am n... See more
I am slowly building my tool collection.What is your favorite and most trusted brand of tools, most used piece of equipment, dual use tools and is there anything that... See more
My case to carry my older leatherman finally wore out and the replacement is too big ( they don't make the smaller ones anymore ) I have put paper and other smaller t... See more
I would like to make a lamp with the stem going through a stack of books. I have only a battery operated drill which will not even go through a paperback book. I’m ... See more
Need to re-secure a wood slat to the floor, but, need to drill thru the wood for the item I purchased to do that. Need to know what I'm getting into as well!Thanks
I want to do a build using pallets, what is the best way to break down pallets and a good beginner project to get used to working with the materials?