How do I fix the bottom part of my kitchen cabinets?
I'm not sure how to fix the bottom wood part of my kitchen cabinets the wood part fell off. I am on a very low budget.
Related Discussions
Vinyl plank flooring vs pergo (laminate)
I currently have stinky dirty carpeting in my living room and I want to replace it with a durable flooring that can stand up to dogs and kids.
How to remove popcorn ceiling that has been painted?
Does having a paint over a popcorn ceiling change how I'd remove the popcorn ceiling?
I want to put lights under my kitchen cabinets to add more light to my counter top, but my cabinets are flush on the
bottom with no overhang to hide lights. Photos below show what I'm talking about. Any suggestions for how to do this job and make it look professional? Is there a ... See more
Can I cut off a bottom shelf of a kitchen cabinet?
This is an old house and the shelf is basically built using the wall as the back. I want to cut off the bottom shelf so I can place a small refrigerator underneath. ... See more
I have kitchen cabinets with a round corner- how do I update?
They are good quality so I don't want to replace.
How can I cover up my plate rack/cubbies under my kitchen cabinets?
The plate rack under my kitchen cabinets ends up being an ugly catchall. Any suggestions for covering it up? Replacing the cabinets is not in the budget for now!
How do I make over my particle board kitchen cabinets?
I habe particle board kitchen cabinets and they are peeling and look awful. I really want to paint them but i know little of primer and paint. Any suggestions on what... See more
Most lumberyards will have a large bin full of wood scraps free for the taking. In our local lumberyard, many of those scraps are molding just like what's on your cabinets. Since you don't need big pieces, that might be a good way to go.
You should take the door off (there will be a couple of screws for each hinge), lie the door on a flat surface, then glue it & use a couple of clamps while the glue dries overnight. Clamps are not super-expensive & you will find other times you need them. If you clamp it, you could use wood glue - it's not as messy as the epoxy & cleans up with water.
E6000 glue should do the trick.
It looks like it has happened over the sink; the heat and moisture from the sink is most probably causing the glue to dissolve. I would put something on the inside of the door to help keep this from happening again, like a small strip of wood attached by staple, small nails or screws on the inside of the door over both pieces of wood.
you can find scaps of galvanized metal very economical and possibly ad a strip at bottom of cabinets on inside if heat is an issue. you may also use the small squares of screening which you can cut to put in between the the wood you are reattaching on inside.
If you have the pieces. Use a good glue. I like the Loctite brand. It works really well. Or you could drill a pilot hole and then tack the trim onto the cabinet.