Love & Renovations
Love & Renovations
  • Hometalker
  • Leander, TX

DIY Stocking Gift Card Holders

4 Materials
$20
2 Hours
Easy

These are the perfect project for the holiday gifts. Sometimes a gift card can feel impersonal, but if you add a fun DIY project like this, it will make it feel much more special! If you love this idea, you can find more DIY ideas on my blog, Love & Renovations.

diy stocking gift card holders

I started off by tracing an outline on a piece of paper - I used the gift card as a guide for the sizing. I just freehanded the shape of the stocking, and then cut it out using scissors.

diy stocking gift card holders

Next, I traced the shape onto a piece of 1/4" plywood, then cut it out using a bandsaw (you could also use a jigsaw).

diy stocking gift card holders

To make the back, I just cut out two small pieces of plywood that were slightly larger than the gift card and traced an outline of the bottom three-quarters of the card onto one of the pieces. Then, I cut it out so that it was a “U” shape (so the card would fit in it, as pictured above.

diy stocking gift card holders

To assemble, I glued the two back pieces together, then glued both of them to be back of the stocking (with the u-shaped piece sandwiched iin the middle to create a pocket for the card! Finally, I did a combination of stain and paint on the stockings to decorate them and get them ready to hand out!


This is a really quick and simple project that will jazz up any gift cards you're planning on giving out this holiday season. See more details and photos on the full blog post!

Suggested materials:

  • 1/4" plywood
  • Bandsaw
  • Stain + paint
See all materials
Love & Renovations

Want more details about this and other DIY projects? Check out my blog post!

Go

Have a question about this project?

Join the conversation

Your comment...