You would need a center punch to mark where you want to drill and dimple the coating. Then use a high speed steel drill bit. Start slow to get the hole started then medium speed with slight pressure. Don't force let the bit do the job.
Start with a small drill bit and get larger gradually and you will be less apt to shatter or crack the enamelware. As was suggested before, let the drill bit do the work. If you apply too much pressure the end result will be disastrous.
There is a molding being sold in England, at least, called Wood U Bend. It can be heated to allow bending. I have not yet found a source from which to get it in the U...
See more
I'm a senior, attempting to use caulk gun for the first time. Have my "cannister" of caulk, cut the top off ... nothing will happen. Takes all my strength to "pump"...
See more
I am putting up a backsplash using a sheet of new corrugated metal. What is the best type of screw to use for attaching this to the studs on the wall? I need somethin...
See more
You would need a center punch to mark where you want to drill and dimple the coating. Then use a high speed steel drill bit. Start slow to get the hole started then medium speed with slight pressure. Don't force let the bit do the job.
Don't crack the enamelware https://www.ehow.com/how_6942600_do-cut-hole-enamel-ware_.html
Start with a small drill bit and get larger gradually and you will be less apt to shatter or crack the enamelware. As was suggested before, let the drill bit do the work. If you apply too much pressure the end result will be disastrous.