Tried that. Ended gouging the subfloor which looks like particle board in some areas. Other areas look like real wood. So I used a scraper and pulled up the vinly but it left the felt backing and the underlying glue
Remove the baseboard, start at one edge and push the scraper under the vinyl to start. It may pull up in strips or you may have to use the scraper under the whole thing. Sand the subfloor to get rid of the excess glue before laying down anything else.
Would be cheaper to rent a sander. The people at the tool rental place will know what is best. Probably something that would cost big bucks if you bought it but will get the job done much faster.
I know the vinyl is not all that old, just a few years but doesn't go with the vanity that was placed after, and there were 5 indoor cats! Reeks even after removing. Sprayed with enzyme this evening. Thanks ALL for the suggestions.
I'm trying to remove worn-out sheet vinyl and uncover the 1930s porcelain tile underneath, but the vinyl is leaving behind this felt-like grey paper stuff that's stuc...
See more
Is it glued down? If so you will need a scraper on a long pole to peel it up. Sorry not an easy thing to do.
Hi Jill! There are so many great sites to go to for assistance. Check these out!!
https://www.bobvila.com/articles/how-to-remove-vinyl-flooring/
https://www.bing.com/videos/search?q=How+do+I+remove+bathroom+vinyl+flooring%3f&qpvt=How+do+I+remove+bathroom+vinyl+flooring%3f&FORM=VDRE
https://www.diynetwork.com/how-to/rooms-and-spaces/floors/how-to-remove-and-add-vinyl-flooring
Remove the baseboard, start at one edge and push the scraper under the vinyl to start. It may pull up in strips or you may have to use the scraper under the whole thing. Sand the subfloor to get rid of the excess glue before laying down anything else.
Would be cheaper to rent a sander. The people at the tool rental place will know what is best. Probably something that would cost big bucks if you bought it but will get the job done much faster.
Yes - what Mogie says. rent a sander.
You should have had it checked for asbestos before you began. At least wear a mask when sanding.