Asked on Dec 10, 2018

How do I reupholster this curved chair?

Pam WalkerBucko2000Lucy Marie Bernier
+4

Answered

How to make cover like old one but prevent wrinkles and bubbles. When I removed old cover it was glued partially to foam under it and it just ripped pieces of foam.

q how to reupholster curved chair
q how to reupholster curved chair
6 answers
  • Debra R. Roberts
    on Dec 10, 2018

    What a mess. You have to replace the foam. Cover the foam then reattach it to the chair

  • Onawaygram
    on Dec 10, 2018

    mold pieces of foil taped together then lay out flat to make your pattern

  • Sal3170064
    on Dec 10, 2018

    Can you remove the top from the base? If you can remove the top cover then do so.

    If you can, then lay the fabric over the chair top, making sure that it is equal all around, allowing the fabric to go underneath to were the other fabric finished.

    Start in the middle where the chair curves. Stretch it across and staple to the back. Then repeat on the other side. Then do the middle of the top and the bottom stretching it straight. Then you fill in with the staples, finishing with the corners. Then add any backing fabric to cover the staples. You can cover any additional staples with braid. Stick it on using hot glue.

    • Nata Donahue
      on Dec 10, 2018

      No it is single piece. I can remove old cover and replace foam where needed but my main question how I can secure leather on curve so it could move a little but not getting folds and bubbles like old cover. I was thinking maybe reinforce with elastic strapping over foam and with flexible glue attach leather to strapping?

  • Lucy Marie Bernier
    on Dec 11, 2018

    Need a knitted type material. Which will form to the shape of the chair. Make it like a large pillow case . Sewn on top and tuck under in front. Make adjustments to the side underneath. Cotton will be difficult to follow the form. But a knitt combination will work better. Good Luck it can be done.

  • Bucko2000
    on Dec 11, 2018

    I think that your idea sounds the best. The fabric was glued for a reason -- probably to hold that curve in place. All of these ladies know what they are doing, but that center curve is what needs anchored.

  • Pam Walker
    on Dec 11, 2018

    Remove old foam & scrap any remaining glue off, cover the chair with bedsheet fabric, then a final fabric choice, then attach the chair. If it's an outdoor chair, place a lining of plastic between the 2 layers of fabric so you could remove the outer fabric & wash & replace when needed.

Your comment...