How to unglue glass table top from chromed steel table legs?
Glass 10mm thick.Glued surface=4 50mm diamcircles. Would heat on circles crack glass?
Related Discussions
Vinyl plank flooring vs pergo (laminate)
I currently have stinky dirty carpeting in my living room and I want to replace it with a durable flooring that can stand up to dogs and kids.
How to remove popcorn ceiling that has been painted?
Does having a paint over a popcorn ceiling change how I'd remove the popcorn ceiling?
How to apply peel and stick wallpaper?
I want to spruce up my walls with peel-and-stick wallpaper. Has anyone used this before and can advise me as to how to apply it properly?
How to stain wood floor?
I've heard staining is a good technique for updating floors. So how do I stain my wood floor?
How do you remove melted wax from the top of a glass table?
In blowing out the two lit candles on my glass table, it splashed melted wax all over the top of the glass table. How and what do I use to to quickly, effectively and... See more
Curb side find! What would you do?
I found this in the curb this morning on my way to work. Needless to say I'm late :) does anyone know anything about this piece? What would you do with it? Paint? Res... See more
I would think a hairdryer or heat gun will soften the glue, just dont heat it up too much and melt the rubber.
Are you sure it's just not stuck? They don't usually glue glass to a chrome base. Try a little harder to pull off. Don't use heat gun near glass. Hair dryer ok.
If it is tempered glass, you could try a hair dryer. Just make sure you have the glass warm so that the temperature difference won't cause it to crack. Hold it so the heat hits the edges around the leg tops and loosen them one at a time if you can and get rid of the disk or glue that is under it so that it doesn't restick itself when it cools.
I got it.Cut a circle in thin cardboard.Glued that around metal leg circles.left to part dry.Then heated glass other side of circles,then slipped paintscraper between cardboard and glass.then gently tapped around metal circle keeping heat on glass'
Off it came !!!!Thanks for suggestions