How do I correct my kitchen cabinets that were put in too high?

+16
Answered

I had my kitchen remodeled and my contractor put my cabinets in way too high for me even to reach on the oven side. They also are much deeper than they should be. I have slanted walls so it’s difficult to fit them. But this looks like a mess to me. How many inches should be from the floor to the bottom of the wall cabinet? I heard 52 inches I’m not sure if that’s right but also any ideas on the slanted walls? I know the cabinets should be lower which will reduce the need for all the open space in the back but covering it all up is still a challenge. Any help will be appreciated.

q how do i correct my kitchen cabinets that were put in too high

The slanted wall before cabinets

q how do i correct my kitchen cabinets that were put in too high

Well there they are. From 12” to 19”

q how do i correct my kitchen cabinets that were put in too high

I can’t even reach the microwave much less the cabinet. Those are on a straight wall. But way too high. And I want to add crown molding. Thank you!

  13 answers
  • CJ CJ on Mar 04, 2019

    I would call the contractor to tell him/her of the error. It's possible the contractor had employees making the installation and is unaware of the issue. Be polite, it could be just a mistake, give them an opportunity to make it right. But do make it clear that you are disatisfied with the installation.


    If the contractor doesn't make it right then you should be able to take legal action against him/her.


    Good luck!

    • Maureen Maureen on Mar 06, 2019

      i have taken your advise. I have spoken to the contractor. He is going to fix my cabinets. I will post results after he corrects them and you can tell me what you think. Thank you!

  • Charlene Ballantine Charlene Ballantine on Mar 04, 2019

    What was that guy thinking he must have been a tall contractor LOL. But I think you could drop them down and float the back of them and place crown molding on top of the cabinet and sit plants or knick knacks on top

    • Maureen Maureen on Mar 06, 2019

      Thank you Charlene. Actually he’s short too! Haha. I have made made him aware of the situation and I hope it gets corrected promptly. And thank you for the drawing.

  • Charlene Ballantine Charlene Ballantine on Mar 04, 2019

    Drop them down just the way he has them set up by floating the back of the cabinet then add crown molding to the tops of the cabinet and in the space you could put whatever you'd like plants or something

  • William William on Mar 04, 2019

    54" from floor to bottom of wall cabinet. There should be 18" from counter to bottom of wall cabinet. For backsplash, appliances, and ease of access. Call the contractor back to correct the installation. I hope you didn't pay him in full and sign off on the install. Standard wall cabinet depth is 12 inches. I hope they didn't remove the backs off the wall cabinets. No need to do so. They should have hung the wall cabinets on a french cleat on top, then add wood behind the cabinets on the bottom. Finally screw the cabinets into the walls,


    French cleat

    https://www.homedepot.com/p/Hangman-30-in-Professional-French-Cleat-CBH-30/206827479


    http://kregjig.ning.com/photo/metal-french-cleat-from-home

    • Maureen Maureen on Mar 06, 2019

      Thank you William. I am going to suggest that. Right now they look unfinished and messy. I think that sounds like a much better way to hang these.

  • Giff Giff on Mar 05, 2019

    Like William said upper kitchen cabinets should be 18" from counter top, and there should be no problem floating out the bottoms, to make them hang properly. Get that contractor back in there to correct the problem, if he is a reputable one he should be willing to make the fix! If not then take him to court! Good luke.

    • Maureen Maureen on Mar 06, 2019

      Thank you Giff. I do think Williams idea is a very good one and I am going to tell my contractor about this way of hanging the cabinets and definitely moving them down.

  • Colleen Jones Colleen Jones on Mar 05, 2019

    I am 5 foot 1 (and shrinking...) I've worked with several contractors - 5 foot 11, 6 foot 5, 6 foot 7. So you KNOW I've had discussions about cabinet height! Height from the floor is MINIMUM 5 foot 2 inches. Tall guys say 'Oh that's too low, I'd hit my head everytime I chopped an onion on the counter."

    "You will quickly learn 'sense memory' in this kitchen to prevent bumps - where I'll never reach the lowest level without a stepstool." "And your last check will be signed my me.....so shorter is better, don't you agree????"

    But I learned not to insist on 'my way' - I just went to the cabinet manufacturer and asked for the usual dimensions for installation of 24, 28 and 30 inch wall cabinets. And surprised the 'contractor' with the 'standards' for wall hung cabinets. These are developed by engineers (not decorators) to accommodate most. But if you are very 'vertically challenged' consider that the ADA developed 'handicapped standards' about 25 years ago, effectively declaring there are no 'RULES' for this....may be that is why they are called CUSTOM cabinets :).

    This is also why I make sure I'm around on install day :)

  • Judy in Canton. Judy in Canton. on Mar 05, 2019

    Nice size kitchen and beautiful cabinets. I would consider relocating cabinet over the microwave to over the refrig, lower the micro and set it on a shelf with another shelf above, for plants, knick knacks and lower the cabinet next to it. That is the only straight wall that you have. Looking at the construction of the upper sink wall cabinets, that may have been the best placement to anchor the cabinets, I would remove them and use open shelves. Repurpose those cabinets into an island, you have the room. Good luck.

    • Maureen Maureen on Mar 05, 2019

      I had open shelves when I bought this house but I live in the mountains and it’s so dusty and dirty. I would have to wash the dishes all the time before using them. And you can see how hard it would be to put them all away! Lol

  • Danielle Danielle on Mar 05, 2019

    Yes, 18" from countertop to the bottom of the cabinet. However, I'd like to make a different suggestion. On the slanted wall, why not rock that feature and use open shelving instead? Then have cabinets on the straight wall that even go above and around the fridge to make it look more custom? I know we can't see past the right side of the fridge to see what space there might be, but even if it's just a tiny space a plain panel would make a huge difference.

  • Jokarva Jokarva on Mar 05, 2019

    I would pull those cabinets on the sink wall and replace them with open shelving. There's just no really good way to make cabinets work on a slanted wall.

  • MTzilla MTzilla on Mar 05, 2019

    Definitely good ideas to remove the cabinets on slanted wall and use open shelves. You can repurpose the cabinets by stacking them to create a pantry, or build an island, as suggested. Personally, I would do away with all upper cabinets as I can’t reach them either. Looks like a great sized window on that wall (where the cabinets were) and I like how it opens up your work space view & brings light in. If you don’t want open shelving, and are doing away with upper cabinets, hang a beautiful, colorful artwork above the counter where the cabinets used to be.

  • Linda N. Linda N. on Mar 05, 2019

    Get back to the contractor asap. Send pics of the finished kitchen. It looks like they did a beautiful job on the cabinets - except for the height. Stay professional, but if contractor fails to lower the cabinets, tell him you will report him to the Better Business Bureau in your state. That's a quick way to officially report him and could affect his reputation. In Louisiana a contractor has 30 days to explain to the Bureau what happened. The homeowner then can agree or disagree and pursue a complaint. Much better than vague threats to sue- and cheaper for you.


    On a practical "make your kitchen fit you" note, my very short mother used one of those rolling step stools that would latch in place when she stepped on it. Very sturdy and stable.

  • Retta Robinson Retta Robinson on Mar 08, 2019

    Never leave the subcontractors alone! Every day there are dozens of small decisions. If you aren't there to discuss options and decide, the workmen will do it the most expedient way--whether that is the right way, the best way or the most aesthetic way. They just want to finish the job and get paid.

  • Johnavallance82 Johnavallance82 on Dec 11, 2020

    Hello there,

    Mine are 53". That being said. It depends on what the buy needs them to be. Call back your builder and ash if he will lower them for you. If this is not possible maybe employ a low step to reach them. Builder may have had to fix to strong points in the walls as they are slanted?

Your comment...