Sandra Davis
Sandra Davis
  • Hometalker
  • Coolidge, AZ
Asked on Apr 8, 2019

How to get hose off faucet thats stuck with alkaline?

Sandra DavisSethPamela
+8

Answered

The hose broke off connector that was connected to the faucet. There is alkaline all around the connector. I've tried socking with vinegar didn't work. Can someone help.

11 answers
  • Lynn Sorrell
    on Apr 8, 2019

    CLR and a pipe wrench put the CLR on a paper towel or cloth and wrap it around the area let it sit on it about 15-30 mins then use wrench to gently turn it loose repeat if needed and add some CLR as you are turning it.use the CLR cloth on connector under wrench so you can grab it easier

  • Unique Creations By Anita
    on Apr 8, 2019

    You can spray some WD40 on and leave I for about 30 minutes them scrub it off with a brush.

  • Betsy
    on Apr 8, 2019

    Remember, turn it clockwise to loosen, you may be tightening it:)

  • Kmdreamer
    on Apr 8, 2019

    Leave it on put new hose over it get a strap you tighten with a screw till it gets tight to hold on

  • Linda Sikut
    on Apr 8, 2019

    Hi Sandra,

    I'd spray it well with WD-40 and let it sit to do its work. If it's still a little stuck, use a wrench to see if you can get it loose. Wishing you the best.

  • Cindy
    on Apr 8, 2019

    Hi Sandra. Begin by purchasing a can of PB Blaster for penetration. Spray it liberally and leave 10 or 15 minutes. Then twist it using Channel Locks. If you get any movement, twist it back and forth. You can spray more PB Blaster if necessary. You can find the PB Blaster and channel locks at any hardware store, home improvement store, Walmart, etc.

  • Pamela
    on Apr 8, 2019

    Try some WD40 , that should work , you might need to use a wrench or channel locks . Once it's off clean off both areas well . Then before replacing the hose , rub some Vaseline on the treads of the faucet . To make it easier to remove the next time .

  • Sandra Davis
    on Apr 8, 2019

    Thank you all your the best. I will try all until I can get it off. Pamela that's for the Vaseline advise. I was thinking grease of some kind before letting this happen again.

  • Seth
    on Apr 9, 2019

    Sandra,

    Do not use vaseline (or any other petroleum based product). It will cause the rubber or silicone O-ring in your hose to deteriorate. Use a paste type thread sealant or teflon tape to prevent leaks. You can also use an anti-seize compound.

  • Sandra Davis
    on Apr 9, 2019

    Thank You Seth for the advise. the Teflon tape sounds good. I might just undo the hose after each use. Lot of hassle but wont get stuck again lol.

  • Sandra Davis
    on Apr 14, 2019

    Got my hose off woohoo. Now I will never leave a hose connected anymore. Again thank you all for your support and help.

Your comment...