Can these cabinet doors be transformed into plexy panels?

Question

Suzette · Answer

Hi Juanita, You sure can! Here's a how to video. they are replacing with glass, but the principle is the same. https://www.youtube.com/watch?v=-6HqxKZzLk4

Have fun!

Rymea · Answer

Plexi glass is very hard to maintain; special cleaners, scratches, get cloudy etc.. You should use glass if at all possible.

Patti Weber · Answer

I cut out the middle panels of my cupboard doors and replaced them with glass. But first I used label making tape to block off an elongated tic tac toe design, then had the glass sandblasted at an automotive shop. This resulted in a frosted glass with clear design lines on them. I love it!!

John Biermacher · Answer

Yes and I agree with the earlier comments about using glass instead of plexiglas. The suggests video covers the general procedure quite well. I have had better luck using a router with a rabbet bit and a guide wheel rather than a straight bit. The guide wheel runs of the front lip, while the cutter removers the back lip. If you decide to tackle this and want more detail, feel free to reply.

Pamela · Answer

Hi ! I covered my wooden cabinets with beadboard , using lock tight super glue.

I don't see why you couldn't use the same technique, I only covered the center part , because I hated the 1970's

Scalloped insects, but you should be able to cover the full front. I know this isn't your style , but this shows the process . Good luck !

Can these cabinet doors be transformed into plexy panels?

Suggested Project Book

Make Your Pumpkin Look Magical Before You Can Say Bibbidi-Bobbidi-Boo

Other

More

Can these cabinet doors be transformed into plexy panels?

Suggested Project Book