How to splice into an existing backsplash?

Bev
by Bev

We have to add some more backsplash as we are renovating our cupboards. Is it easy to do? We have Casa Roma Glass backsplash that comes in 12" by 12" pieces.

  3 answers
  • K. Rupp K. Rupp on May 15, 2019

    What I am understanding is that you have to add to your existing backsplash because you took away a cabinet? Or are you saying that you need a temporary backsplash because you took a cabinet down to renovate it, but you are putting it back up? If you need a permanent solution because you removed a cabinet, I would get tile that complements the existing backsplash very well. Sort of like what you see above a stove. sometimes the backsplash is different in that section but complements the backsplash that goes around underneath the cabinets. If you need a temporary solution to protect a wall while renovations are going on, look at some peel and stick tile backsplashes they have on the market. I hope I understood your question. Good luck!

    • Bev Bev on May 15, 2019

      Yes, we are moving cabinets up and need enough of the tile to cover about 2 inches all around plus a larger area. We can still purchase what we have so we would like it to match. Thank you

  • Kathy Gunter Law Kathy Gunter Law on May 15, 2019

    Installing wall tile isn't difficult. Cement board on the wall first, we screw it in with drywall screws. Using pre-mixed mastik you apply it to the back of the tile then place it on the wall. You will need to figure out the spacing of your existing tile and purchase spacers. Place a spacer on each corner and put the next piece of tile on the wall. Wipe away any excess as you go, including in the grout area or you will have a hard time later.

    Make sure to purchase a tile saw or blade to cut the type of tile you have. That is probably the most difficult part of the job.

    Once all tile is in place, let it dry. After that you can grout. Once grout is dry, seal.

  • Linda Linda on May 15, 2019

    The best thing to do is cut out some of the tiles in a staggered way so that when you add the new ones it will not be noticeable that you started a new sheet.