How to remove epoxy from table top?
by
Bonnie
I had many bad spots and bubbles. I have been sanding it with 80 grit paper and not sure how long to continue with this paper or should I switch to a fine paper. And what grit. A few spots are too the wood. Or would it be better to use paint thinner or something?
Related Discussions
Suggested Project Book
Thanks
Fine grit sand[paper won't work at all. 80 grit is a very coarse paper and should do it but you'll go through a lot of paper and it will take forever depending how thick the epoxy is. You can try a coarser paper like 60 grit but still will take a long time. I would try a heat gun or hair dryer on high to soften the epoxy and scrape it off with a putty knife. Then sand off the rest.
Hi Bonnie, sorry you have bubbles and bad spots in your table. Here is a suggestion I hope will fix it. Good luck How Can I Get Rid Of Bubbles In My Cured Resin? – ArtResin
Yes, you CAN get rid of bubbles after your resin has dried! ... TIP: A torch is the BEST line of defense against bubbles - nothing beats that flame to zap out ...