DIY Embossed Mermaid Flower Pots

Country Chic Paint
by Country Chic Paint
11 Materials
$25
1 Hour
Medium

Learn how to make your own DIY mermaid flower pots with Texture Powder, Metallic Cream, and All-in-One Decor Paint!


Step One


Seal the inside of your unpainted terracotta pot with Tough Coat to prevent dirt, moisture and contaminants from leaching through and staining your work. You can opt for Clear Coat instead of Tough Coat with 3-4 coats.


NOTE: the outside of the pot does not need to be painted! We were re-using a pot that had already been painted, but the plain terracotta finish is absolutely fine as a starting point icon

Step Two


Trace out your general design using a template, or free-hand the design if you're feeling creative.

Step Three


Mix Texture Powder with any color paint in a 1:1 ratio until you have the consistency of buttercream icing.


This will be painted over later, so it really doesn't matter which paint color you choose.

Be careful it isn’t too runny as you’re working on a vertical surface and you don't want to create drips!

Stir until the lumps have dispersed. Scoop this mix into a Ziploc bag and seal closed.

Step Four


Use scissors to snip the tiniest little hole in one bottom corner of the bag. This will allow you to “pipe” on the mixture just like you would decorate a cake. It the hole is too big, the piping will be rather thick and may drip, crack, or take longer to dry. Start small and make the hole larger if necessary.

Step Five


Go slow and steady as you trace or free hand the scallop design. If you’re quick, you can wipe off any mistakes as you go!


Step Six


Let the scallop design dry for 12 hours. You should be able to gently press the edge of a fingernail into the design and it will only make a small indent - if any. Smooth out any unwanted texture with fine sandpaper when the design has hardened and completely dried.

Step Seven


Using a variety of artist brushes, apply your three chosen colors in the order you want, painting a 2nd coat if needed. Keep the colors from touching too much until you are ready to start blending.

Step Eight


Have a cup of water on hand for blending, and plenty of brushes so you don't cross-contaminate the colors. Starting with the bottom color, slowly add a bit of water to paint and blend with the edge of the middle layer. Alternate bringing the middle color down, and the bottom color up. As you apply these layers you can apply a light “wash” of water that will also help blend. Catch any drips with a lint free towel, and take a break to let the pot dry awhile if you are overworking the layers already on the surface.

Use the same blending method for the top color, bringing it down into the middle color.

Step Nine


Let the paint layers dry for at least 1-2 hours before applying the Metallic Cream of your choice. In this case we used Lucky Penny (copper) for our green and teal pot, and Silver Bullet (silver) for our pink and purple pot. Use the fine detail (# 4 or # 6) angle brushes from our Artist Brush Set to apply Metallic Cream to the raised scallop design. The ¾ Filbert is perfect for the thick band at the top of the terracotta pot.

Step Ten


If the project will be going outdoors, seal the outside with Tough Coat for maximum durability and ensuring your beautiful work lasts. It is okay to leave the surface as-is if you like the matte look of the paint, or if the pot will be staying inside.

Suggested materials:
  • All-in-One Decor Paint   (Country Chic Paint)
  • Texture Powder   (Country Chic Paint)
  • Artist Brushes   (Country Chic Paint)
See all materials
Frequently asked questions
Have a question about this project?
3 of 5 questions
  • Anita Villasenor Anita Villasenor on May 25, 2020

    Is there any way u could make a step by step video on how to do this craft? Thank you.

  • Derek Derek on Jul 01, 2020

    Is it not fragile? If it will stand in the sun for a long time or something happens to him in the water?

  • Bill Anderson Bill Anderson on Apr 02, 2021

    That's very pretty, but where do you get these products?

Comments
Join the conversation
3 of 37 comments
Next