Sprayer hose gets tangled with valves under the sink. How do I keep it from doing that
I hate that. I made a noose out of a zip tie. Attached to drain pipe, And hung above the valves. Kept it tight enough to hold up but loose enough so it could move.
At one time a weight that slipped over the hose came with replacement hoses. Eventually you had to buy the weight as a separate piece which probably no one did. What I did was use a few steel washers and slipped them on the hose. So when it retracts under the sink the weight of the washers take it straight down and no tangling.
Here are some videos that will show you ways to deal with this. Good luck.
I used sn old milk jug. I gut it to fot over the valves and zip tied it in place! Recycle/reuse.
Thank you. Will try this