How do I transition a wood plank accent wall w/ a bullnose corner?
This is an old mobile home we have remodeled. The wall has since been painted, but we want to do a wood accent wall. Although I am not sure what wood I want to use yet, I am looking for suggestions on how to transition the wood at the bullnose corner on the right side of the wall. The rest of the walls have been sheetrocked, textured and painted.
Related Discussions
Vinyl plank flooring vs pergo (laminate)
I currently have stinky dirty carpeting in my living room and I want to replace it with a durable flooring that can stand up to dogs and kids.
How to remove popcorn ceiling that has been painted?
Does having a paint over a popcorn ceiling change how I'd remove the popcorn ceiling?
How to apply peel and stick wallpaper?
I want to spruce up my walls with peel-and-stick wallpaper. Has anyone used this before and can advise me as to how to apply it properly?
How to stain wood floor?
I've heard staining is a good technique for updating floors. So how do I stain my wood floor?
How do I fix wallpaper that's peeling off?
The wallpaper on the corner of a wall in my house is starting to peel off. Any advice about the best way to glue it back?
How to seal the seams of vinyl wallpaper?
We are renovating our guest bathroom. We put up vinyl wallpaper along the tub/shower wall. I am not worried about the wallpaper itself getting wet because it is viny... See more
I am guessing that you are thinking in terms of shiplap. If that is so, rather than have that edge be all board ends you could end the run with a vertical board of the same thickness. Then use a belt sander to sand the right side into a matching curve. If you have the right setup you could use a router to put the curve on the board before you install it. If you don't want to go through all of that you could end the wall with a piece of molding that kind of continues the curve. Or you could finish the wall with two vertical boards, one on your wood covered wall and one around the corner eliminating the bull nose completely.
You can do as V Smith suggested, that was my first thought, making a "frame" for the wall. I would do the vertical board on both sides.
You can add wood outside corner trim so you don't see the edges.
Hello. They do sell trim transition pieces that you put on the corner. I used to have them at my old house.
Home Depot and Lowes sell corner trim. I would do board and batten on that wall. You can do the cheaters kind, where you use furring strips and molding and then paint whatever color you want.
What did you end up doing? I have the same set up...and same problem