How can I put roller wheels on a small kitchen cabinet?
Related Discussions
Vinyl plank flooring vs pergo (laminate)
I currently have stinky dirty carpeting in my living room and I want to replace it with a durable flooring that can stand up to dogs and kids.
How to remove popcorn ceiling that has been painted?
Does having a paint over a popcorn ceiling change how I'd remove the popcorn ceiling?
How can I hide a stackable washer \ dryer in the kitchen of my small ?
It is directly next to my refidgerator
I want to put lights under my kitchen cabinets to add more light to my counter top, but my cabinets are flush on the
bottom with no overhang to hide lights. Photos below show what I'm talking about. Any suggestions for how to do this job and make it look professional? Is there a ... See more
How do I correct my kitchen cabinets that were put in too high?
I had my kitchen remodeled and my contractor put my cabinets in way too high for me even to reach on the oven side. They also are much deeper than they should be. I h... See more
How can I repair the side edge of kitchen cabinets before painting ?
The sides of my kitchen cabinets are made of compressed wood with a laminate over top. The edges are showing wear and possible water damage. What can I do to repair t... See more
Can I cut off a bottom shelf of a kitchen cabinet?
This is an old house and the shelf is basically built using the wall as the back. I want to cut off the bottom shelf so I can place a small refrigerator underneath. ... See more
Hi there! if its wood you can purchase castors at your local home improvement center and simply screw them on the bottom. If its metal though I think I'll need pictures to give better advice on how to add wheels.
You can purchase dollies like this
https://www.harborfreight.com/18-in-x-12-in-1000-lbs-capacity-hardwood-dolly-63098.html
This shows how to add swivel casters: https://www.hgtv.com/design/rooms/kitchens/how-to-build-a-diy-kitchen-island-on-wheels
The hardware store has casters that you can screw in. It is super easy if you know how to use a screw driver.