There is a molding being sold in England, at least, called Wood U Bend. It can be heated to allow bending. I have not yet found a source from which to get it in the U...
See more
I'm a senior, attempting to use caulk gun for the first time. Have my "cannister" of caulk, cut the top off ... nothing will happen. Takes all my strength to "pump"...
See more
I am putting up a backsplash using a sheet of new corrugated metal. What is the best type of screw to use for attaching this to the studs on the wall? I need somethin...
See more
I would glue them with wood glue and clamp them for 24 hours until the glue sets.
I would use glue and screws for a more permanent bond.
Crates will probably split, so I would pre-drill the holes and through-bolt them with washers.
Screws would be the best solution, then if you want to take them apart you'll be able to without damaging them too much.
Hello. I will pre-drill a hole and consider using a nut and bolt to secure it together.