Asked on May 23, 2020

Best product for sealing very porous tile?

ScottWilliamLibbie B
+22

Answered

Hi fellow home talkers! How are all of you doing? If anyone could help me out...I would really appreciate it!


We have a very porous PORCELAIN tile in our kitchen. It is made to look like white travertine stone. We got it instead of travertine at the time because it was porcelain, didn't stain like travertine and "didn't need to be sealed". The problem is that it has become difficult to clean since it is so porous. When scrubbed with a machine scrubber it does clean up nice, but I can tell I still have to get on my hands and knees to really scrub inside the pits. We are talking hours to get this floor clean!!! It can look like dark seeds even after it has been cleaned because the dirt gets stuck. I have included a couple of pics. The floor that has the worst problem is in the kitchen(of course). First pic is the foyer tile(not bad), 2nd pic is the kitchen tile which was cleaned YESTERDAY!!!


My daughter helps me clean the floors and her biggest complaint is...these floors never look clean. HAHA.


What product would you suggest to seal these tile floors. I have tried to look at products and have no idea what to use on it especially since this tile was not meant to be sealed like travertine. I am hoping a sealer would make them easier to clean? Any suggestions..?



Foyer tile (same tile as the kitchen)- Hasn't been cleaned in a while. Probably closer to what it should look like.

Same tile located in our Kitchen- CLEANED YESTERDAY! Dirt in pits that the scrubber can't get.

9 answers
  • SawHorse Design Build
    on May 23, 2020

    If it is porcelain and not a stone, you don't need to seal it. The issue is that the texture of the tile allows dirt to collect in some of the areas. I had the same issue at my last house. I would use a tile cleaner that is slightly acidic and then use a wet shop vac with the squeegee attachment. After I applied the tile cleaner, I would use a deck cleaning brush to scrub the floor. After you use the shop vac- apply some warm water to the tile and clean again to get any of the residue up. DO NOT DO THIS IF THE TILE IS STONE!!


    You just have to let chemistry and power tools help you since the tile is a challenge.

    • K. Rupp
      on May 24, 2020

      Thank you so much! No, the tile is not stone, it's a porcelain tile so the acid should be fine. How long do you let an acid solution sit on it to you think? I like the idea of the wet shop vac. Thanks so much!

  • I found this product available in Lowe's that might do the trick. Otherwise, I would contact the store where the tile was purchased and see what they suggest. Good luck!

  • Chloe Crabtree
    on May 23, 2020

    Porcelain tile does not need to be sealed.

    • SawHorse Design Build
      on May 24, 2020

      You may be able to fill them with un-sanded grout then seal the new grout but not sure if that would work. Most travertines and other stones do have fillers, however I have never tried this on tile. OR- Perhaps an epoxy filler that gets sanded to smooth out the tile. Might be less work to just replace the tile with a smooth tile though.

  • Deb
    on May 23, 2020

    I searched the answer on line&like anything else,always contact the manufacturer themselves. But this sounds right&if you a re sealing a clean,grout free time,use the sealer before you grout!! A penetrating Sealer for porcelain/Ceramic tile.

  • I use a steam cleaner on my tile and it comes out great. No scrubbing!

    • K. Rupp
      on May 24, 2020

      OH OK.....no I don't have one and I have been wondering how that would work on a floor like this to get the dirt. I will have to get one or see if it works before buying one. Thank you all!

    • K. Rupp
      on May 24, 2020

      Thank you very much for the info. I will definitely check out the link!

  • Libbie B
    on May 23, 2020

    I am on team steam clean over here too!

  • William
    on May 24, 2020

    I go for either the steam cleaner with vacuum attachment or wet/dry shop vac. You need to have something to suck up the cleaner and dirt out of the crevices.

  • Scott
    on May 25, 2020

    I read were you said that this is an actual porcelain tile made to have that travertine look and feel. One being a porous surface, which is actually the reason travertine and other similar material, even grout requires a sealer. This is just my opinion now... The only way I see you fixing the issue you have is a sealer to fill those voids and allow you to have a surface that is manageable to clean. Otherwise dirt and what have you have plenty of hard to get into places for dirt to settle. I think sealing it will have a result that you would be happy with. Best of luck!

Your comment...