DIY Ribbon and Trophy Display

• lumber (I used a 1x8" board for the shelf top and 1x6" board for the back)
• two decorative shelf brackets (or two pieces of wood cut at 45 degree angle)
• dowel
• two small hooks
• orbital sander or sandpaper
• screws
• stud finder
• level
• primer
• paint

First decide how long you want the overall shelf to be (in our case I decided on making it 3ft wide). Then cut your shelf top to that length.

Next decide how wide you want the shelf back to be - remember that the self back plus the brackets should fall within your overall shelf top length. Ultimately how long you cut the shelf back is your preference though. But visually I think that the shelf back and the brackets look best if they fall within about 2 inches of the shelf top on each side. (Side note: If you have a router you can cut a dovetail channel along the back of the shelf back now to make for easier hanging… I do not have one of those handy so I skipped this step and will hang our shelf another way.)Once you have everything laid out, cut your dowel to about 1/8” less than your shelf back length so it will fit comfortably within that space.

After everything is cut, I recommend sanding everything first before you assemble. I love using our orbital sander - it makes for quick work and does a nice job.

Next start assembling. Screw the shelf supports to the backing first, making sure everything is lined up and flush.

Next carefully center the shelf top, making sure it’s flush with the back and screw in.

Now for the fun part - paint! I did one coat of primer and then three coats of semi-gloss white paint, though you could choose any color you wish. I like semi-gloss paint since it has a slight sheen to it and is easier to dust and keep clean.

For hanging - first I measured this wall side-to-side to figure out where the shelf should fall within that space to be centered. Then I marked the studs with a stud finder. To be honest I usually use two different kinds of stud finders when I have to hang something - I use a magnetic stud finder first to identify exactly where the stud is and then a digital one to find the edges of the stud. I’ve found that sometimes the digital ones can be finicky so it’s nice to know where the studs are first rather than get a false stud reading when it could be something else (a pipe, a thick area of plaster on the wall, etc).Then using a level to make sure the shelf was level, I screwed directly into the wall studs through the shelf back making sure to place the screws where they would be hidden by the dowel once I installed it.

Next I hung the dowel by centering it and adding a  simple hook to support it on each side, as shown above (this also hides the screws I used to hang it). And now the project is finished and ready to display ribbons, medals, and trophies!

To hang the ribbons and medals you can easily lift the dowel up and string them on, or loop them around the dowel like I did here. That's it! I hope you enjoyed the project.

{ Please see original post for additional photos and links }

Follow on Instagram for more: @birchlandinghome