These soft and chunky yarns add that warmth we are longing to bring into our homes for the fall holidays. 

We’ve included a video tutorial that will really help you see how to do the finger knitting.

Note: It may be easier to learn the finger knitting technique with the video tutorial.

As the weather cools, I start thinking about fun fall crafts to add for my holiday decor. 

Two days ago we had a huge wind storm come through that wreaked havoc in our area. We will be cleaning up the mess for days.

Not only did we experience 80 MPH winds, but our temperatures also dropped by 40º. It is really starting to feel like fall here! This fall craft is the perfect project to do while cozied up in a blanket.

Begin by placing the end of the yarn between your middle and index finger.

Wrap the yarn behind the middle finger and then around to the back side of the index finger in a figure 8 pattern.

This will form 2 complete loops around your finger. 

Repeat, so you have 2 loops on each finger.

First pull the back loop over the front loop on your index finger. Then pull the back loop over the front loop on your middle finger.

After the first 2 loops are made, pull the tail tight.

Repeat by wrapping the yarn around your fingers again and pull the loops over again. 

Then pull the tail towards the palm of your hand. 

Continue finger knitting until it reaches the desired length. It should reach from the stem of the pumpkin to the center on the bottom of the pumpkin.

To tie off the end cut a 2″ tail and place the loop that was on your index finger through the middle finger loop. Next, take the cut end and thread through the loop and pull.

Continue to make these finger knitted strips until you have enough to cover a pumpkin. It will depend on the size of pumpkin you use. For example I needed about 25-30 for this pumpkin, whereas the large pumpkin took more like 40-45. 

Apply the finger knitted strips for this fall craft by running a bead of hot glue down the groove of the pumpkin. 

Place a knitted strip starting at the top edge near the stem, along the groove to the center of the bottom of the pumpkin.

Once all of the grooves are covered with the knitted strips, cut the tails from the top and bottom of the pumpkin. 

Next, fill in the raised areas of the pumpkin with more of the finger knitted strips. These may be too long for the area.

See the video for how I shortened the knitted strips to fit each spot.

Finally trim any remaining tails.

Once all of the finger knitted strips are on your pumpkin you can embellish it as you wish.

The original stem can be reinserted or a piece of a branch can be inserted. I also cut a leaf from a scrap of fabric and glued it to the top. Finally I added a piece of jute for the curly-q.

I loved this fall craft! These pumpkins look so warm and cozy with this chunky yarn. They just feel like fall!

So what do you think?

This is really an easy fall craft. I bet once you make one, you’ll want to make more.

I’m loving the way they look with my  FREE fall printable.

Thanks for spending some time with us! We hope you’ve been inspired by this quick and easy Dollar Tree DIY. 

For more FALL CRAFTING IDEAS click here.