This video may help:
How to Flatten a Wrinkled Area Rug
Here are some suggestions to try:
Try back-rolling the rug or stacking heavy books on the wrinkles.
Try Steam Cleaning it and keeping it flat whilst drying out! Best wishes.
mix 50/50 warm water and fabric softener
spray wrinkles and they should come out
If they don’t then spray again and turn around get. You may need to get pull tight.
Hello are they natural fibers or synthetic? A steam iron and pressing cloth might be used on natural fibers.
Hi Catherine, hope this helps you get the wrinkles out of your area rug. About 2,640,000 results (0.70 seconds)
I ended up taking a thin towel and wetting it thoroughly and squeezing out the excess. I folded itMore
www.youtube.com › watch
Hi! Sometimes repositioning it will solve your problem. Pull it as snug as possible and put something heavy to weigh it down so they stretch back out. Sometimes rolling it and then unrolling it helps, too. Good luck!
Try this post:
How to Flatten a Wrinkled Area Rug | Hunker
I would get 4 people, one at each corner, and stretch it out. Then put some heavy items on each corner so it will stay stretched. Leave it like that for a few weeks. If you have a steam wrinkle remover, that could help too.
Carpet pads help relieve wrinkles. Get a carpet pad almost the size of the rug to put underneath.
Hi Catherine, I would try wetting it a bit it possible and letting it dry flat. I have a braided rug that gets lumpy and I usually wet it as much as possible and then lay it out in the sun on something flat (patio, dock etc...) and it will dry flat.
Hi Catherine, this video is awesome and easy, hope it helps you!
A lot of times, I've rolled a rug upside down - opposite to the way it will lay normally.
Hi Catherine: If you can wash them, even at a laundromat, do that, but don't dry them, put them in the sun to dry flat. If you can't wash them, then spritz the bottom with water and let them dry face down. Put something heavy on the wrinkles to smooth them out. Good luck
try running the iron over it while it is on the floor
Running the vaccuum over it helps