I have a three by two feet plywood 5mm board that i want to paint. How do i prime or paint it without it warping? I was told that if I paint a strip corner to corn... See more
Hey Hometalkers! I'd really like to give my son's train table a makeover by painting the drawers and staining the rest, but I'm not sure it's possible. The table is m... See more
Does anyone know how to remove existing paint splatters from brick? I have tried everything I know of with no success.
I want to change the master bath to look like an old out house. Paint the walls to look like old wood.I plan on making the cabinet doors out of palet wood. But instea... See more
the rods were welded in a big sun burst pattern more than 50 years ago. I want to spruce it up a bit and hang it
Painted my 6 panel door that goes on to my screened in porch but all i can see is brush strokes and at night when i'm watching tv and look that way all i can see are ... See more
How to paint shabby chic on dark wood
For a temporary look, we are putting in new lauan (sub-flooring) over the top of OSB sheeting on the floors. This is in preparation for future tongue'n groove wood f... See more
I covered a coffe table and end table tops with galvenized sheet metal. I did the toilet bowl cleaner technique to age it. It really didn't do as much as I wanted. Do... See more
Wondering if I could paint a design on outdoor/indoor carpet I have in patio area. There is a roof covering that carpet. If it can be painted, what kind of paint & wo... See more
I just bought a place and want to remove chalkboard paint from the walls in the living room and kitchen. If I sand it down a decent amount will I get an ok finish whe... See more
I am going to paint two bird baths. One with Krylon Sea Glass spray paint and the other with Rust-oleum Multicolor Textured Spray paint. My son says that it will pois... See more
My husband and I recently refinished a buffet table; sanded it, cleaned it, added paint, and gave a distressed look to it. However, we are starting to notice these we... See more
I refinished and restrained my coffee table. The new stain is way to dark and looks awful. Help
I have an industrial metal cart that has both rust and paint. I need to clean it up and strip it. What is the easiest way/ best way?
I painted my laminate cabinets, and it turned out great except... I thought by applying around 4 coats of Polyurethane it would protect the cabinets from scuffing, a... See more