I like Lifestyles Idea. Instead of screwing them to sides of table; drill through table at an angle and put a pin/bolt through the hole(in club) to support the table.(Use heavy washer between the pin and table for better support.) I'm 'seeing' woods as legs, placed at a slight angle like you were holding the club. Check hardware for some fancy toppers, to put on top of the clubs where they come through the table.
I'm seriously considering making this twisty side table that I fell in love with here on Hometalk (By Chasing A Dream), but cutting the wood is a bit too ambitious fo...
See more
We took the old popcorn ceiling off in our livingroom and thought we could just paint it. We fixed some hairline cracks where the joint in the sheetrock are, primed a...
See more
Does anyone know what type of hinges are attached to the top of this folding table? The legs fold in toward the back then the top folds down flat against the legs.
I am turning the sides of an old wooden crate into a coffee table top. The wood is similar to pallet wood: unfinished and prone to giving splinters. How might I go ab...
See more
That would be awesome! There are a lot of pictures and ideas on Pinterest! https://www.pinterest.com/pin/567312884286010691/
If you can drill through the shafts, you can screw them into the table top edge. You’ll need a punch, a drill press and cutting oil.
Here is how we made a small table, it might be helpful for you, Here you go https://bushraslifestyle.com/diy-computer-desk/
Hope it helps!
Bushra
I like Lifestyles Idea. Instead of screwing them to sides of table; drill through table at an angle and put a pin/bolt through the hole(in club) to support the table.(Use heavy washer between the pin and table for better support.) I'm 'seeing' woods as legs, placed at a slight angle like you were holding the club. Check hardware for some fancy toppers, to put on top of the clubs where they come through the table.