I used a regular cylindrical grinding bit to go thru china. I start it on an angle then bring it up to be perpendicular to the surface. Don't push let the tool do the work. I do this thru a small puddle of water so the bit stays cool. You can create a puddle by building a wall out of clay around the spot where you want to cut and filling it with water. I find it helpful to find the right speed by practicing on an unimportant piece first.
There is a molding being sold in England, at least, called Wood U Bend. It can be heated to allow bending. I have not yet found a source from which to get it in the U...
See more
I'm a senior, attempting to use caulk gun for the first time. Have my "cannister" of caulk, cut the top off ... nothing will happen. Takes all my strength to "pump"...
See more
Hi Eric, you would use a Dremel diamond cutting disc. https://www.amazon.com/Dremel-545D-545-Diamond-Wheel/dp/B00004UDI9
You can also find them in home improvement stores too.
I used a regular cylindrical grinding bit to go thru china. I start it on an angle then bring it up to be perpendicular to the surface. Don't push let the tool do the work. I do this thru a small puddle of water so the bit stays cool. You can create a puddle by building a wall out of clay around the spot where you want to cut and filling it with water. I find it helpful to find the right speed by practicing on an unimportant piece first.