Concrete Eggshell Planters For Air Plants

10 Materials
$10
2 Hours
Easy

You can make adorable air plant planters from eggshells that are so durable, they’ll last year over year. The secret is adding concrete.


These concrete eggshell planters are an improved version of the cute little planters made of eggshells that you may have seen on Pinterest.


I mean, as adorable as they are, they might make it through one Easter, but if they turn out adorable and they break in between now and next Easter then it’s going to kind of a bummer.


But don’t worry, there’s an easy solution for this. You can make little eggs shell planters last many, many years.


Just add a little cement to skim coat the inside, and you’ll have a super easy and extremely, – yes, I said “extremely” durable planter.


How are these Easter eggshell planters so durable?


Well, eggshells alone are quite durable. Haven’t you ever mystified by how hard some of those suckers are to crack on the edge of your mixing bowl?


However, they aren’t going to be durable enough to pot tiny plants inside, especially year after year.


With these eggshell planters, you’ll want to leave the casing intact with the shell.


Are you worried about the shells starting to yellow?


Well, only time will tell, but I can tell you that I made my first concrete eggshell planter over 3 years ago and it’s still as white as the eggs in my refrigerator.


STEP 1 | Select The Eggs For The Eggshell Planters

Select your eggs based on smoothness and lack of markings. Some eggs get a bumpy texture, so I chose ones that were nice and smooth, which most in the carton were. 

Start from the pointed end of the eggs. Hold the egg carefully, but securely in your hand with the pointy end up. 


Now take the sharp tip of the bookbinding tool and gently press in the tip to first make a single hole and then add a few more right next to it.


Tap that area with the blunt end of the tool to crack a small opening.

Now use the tip of the tool to lift up on the shell from inside to start widening the opening. 

At this point you can either use your fingers to continue pulling up on the edges and peeling them back carefully to remove them, or use the blunt end of the tool to tap the edges inward and then pull the cracked edges out. 


I didn’t want to waste the eggs and wanted to preserve them so I could make scrambled eggs, which is why I went for the peeling back method.


This helps keep the shell from breaking off and going inside. 

If you are okay with not using the actual egg, then it’s probably easier to use the blunt end method. See how to do this in the first part of Step 3.


Since the main goal right now is to get the egg out, you only need to make it a little wider than a nickel. 


You can peel back the broken pieces that are still attached to widen the opening, and then dump out the egg.

If any of the whites or egg yolk has gotten on the outside of the shell then rinse it off to prevent the outside of the shell from being slippery.


The opening needs to be wide enough to pot a plant, so chip the edges off by pressing backwards on them until your opening is about the size of a quarter or a little larger. 


STEP 2 | Create The Bottom Hole For The Planter’s Stability

Turn the eggshell over to work on the bottom of the eggshell planter. 


Do the same as you did with the pointy end of the egg and create a few small holes and then use the blunt end of the bookbinding tool to dent the shell inward. 


This hole only needs to be the size of a dime which will allow you to have a flat bottom so the eggshell planter doesn’t roll.


Rinse again if needed, and then place the eggshells back into the egg carton with the bottom rounded side of the egg facing down.


STEP 3 | Mix The Cement For The Planter

**If you love making concrete projects, then check out my Pocket Guide to Concrete Mixes! I tested 6 mixes and made a handy reference chart. It's a FREE download. 😉


Since this is a rapid setting cement, you are best off making no more than six egg planters at a time. 


Lay a couple of damp paper towels next to you, along with one dry one and then mix with the cement and be sure to use cold water to give you a longer working time.


 Add cold water to the mix. It’s important that the water is fairly cold.

Straight from the tap is about right, but if you are working in a warmer environment, you may want to add ice. 


Get the mix to milkshake consistency. This needs to be gloopy —so if you pick up some of the cement and drop it back into the bowl, it should drip like a slow to medium drip. 


Not super wet and fast, and not chunky drips. If it’s too chunky, just add some more water and mix it in.  


STEP 4 | Cast The Eggshells

Now scoop the cement into the eggshells. This can be messy and you’ll likely spill the cement all over the outside of the shell. 


This cleans up easily, so don’t worry about the messy shells right now.


Gently push the cement inside each of them up against the sides of the shell.


The planter’s walls should be about ⅛” thick and the bottom slightly thicker. You’ll need to work at a good pace before the cement starts setting. 


If the cement keeps sliding down on you, then set it down for the moment and move on to the next egg. 


Repeat this for each egg and then go back to the first couple of eggs if the cement was slipping.


By this point, the cement will have started setting which will make it easier to skim coat the insides with.


Set these on your flat work surface.


The bottoms of the shells are open and at first the cement may slip out, just keep working on these, but by the time you finish, the cement will have stiffened enough it won’t drip. 


Finish smoothing the insides and making sure they are evenly coated. I like seeing the cement at the top, so I pulled the cement right up to the top edge. 


You can always add another skim coat after these have cured.


STEP 5| Make The Drainage Hole For The Concrete Planter —Optional

** To see how to make egg shaped cement planters (without a shell), then check out this tutorial. 🙂


If you want to use these eggshell planters for plants other than air plants, then you’ll need to create a drainage hole.


To do this, simply press a Q-tip through the bottom, center of the cement egg to clear a hole.


If the concrete is getting too hard, dip the Q-tip in water to soften the cement and then press. 


Let these cure for an hour. After they have cured, you can safely wipe off the excess cement with a wet paper towel.


FINAL STEP | Refine The concrete Eggshell Planter

If you want your edges to be flat and not jagged, then take the eggs to either a concrete patio or use a brick if you have one and use it as a sanding pad. 


This is the easiest way to grind down the top of the egg. Anything that has a hard rough texture to rub it against should work. 


*Just a mild warning- if you angle the egg too much, you may chip the top edge of the shell off-like this.


So take care to hold the egg parallel with the cement surface. I sanded 7 eggs this way and it only happened to one of them.


Now the concrete eggshell planters are all set to be potted with air plants.


If you love these cute little planters, then you may also be interested in these tiny wine cork succulent planters.

Resources for this project:
See all materials
Any price and availability information displayed on [relevant Amazon Site(s), as applicable] at the time of purchase will apply to the purchase of this product.
Hometalk may collect a small share of sales from the links on this page.More info
Artsy Pretty Plants
Want more details about this and other DIY projects? Check out my blog post!
Go
Frequently asked questions
Have a question about this project?
  2 questions
  • Teri Teri on Mar 03, 2021

    Could this be done using small balloons?

  • Ticia Ticia on Mar 03, 2021

    Very cute but where does one find 'air' plants?

Comments
Join the conversation
2 of 17 comments
  • Mar66401112 Mar66401112 on Feb 27, 2024

    Lovely idea and I do like the look. Don't you mind all those other comments. I do believe the actual eggshells make a more elegant look than using plastic.

  • Katen Katen on Feb 27, 2024

    When I was kid (late 50’s, early 60’s) no way could you go without a new Easter bonnet. Didn’t have much but mom always made sure we girls had bonnet, gloves and a new straw purse. Her friend used to take our bonnets and using colored eggs (match dress) blew out eggs and washed inside. With eggs, l” chenille bunnies or chicks, bits of ribbons, buttons etc made the most darling Easter bonnets for all four of us little girls. A real Easter morning accent. We thought we were “it” in customized hat. After that removed and had bonnet for spring and summer. This brought back happy memory. Thanks for trip down memory lane

Next