3D Fall Wreath
Giving a spin on Fall wreaths by making a 3D wreath/ centerpiece.
Supplies needed
I bought this wire wreath at Dollarama. It is a set of 3 that open up together to form a globe. I bought the Fall florals at Dollarama as well. They have a large variety.
More materials to add
I had some other florals at home, and some burlap ribbon (also from Dollarama), which I used to wrap around each wire.
Adding Burlap
I started twisting the burlap at the top of the sphere first to cover the wire. From there, I began to wrap the burlap around one wire at a time, cutting the extra, and hot gluing it at the ends of each wire. Then repeated this for each individual wire.
Hot glue each end of the ribbon to keep it in place.
Pull off each set of leaves from each stem.
The stems have a bunch if seperate leaves that you can just pull off. When you pull each one off, they're attached to a small wire. I poked the wires into various spots on the burlap and hot glued the leaves onto the burlap to secure them in place.
Make it sturdy
You can either hang the sphere wreath (like a mistletoe) or make a base for it to sit. In my case, I used a scrap piece of wood and hot glued it to the bottom of the wreath, so it could stand.
Make it hang
If you want it to hang, add some jute string by making a loop st the top of the wreath.
I put mine ontop of a marble tray to make it a centerpiece for my coffee table.
Use this for early Fall decor or a Centerpiece
This 3D wreath will also double as my Thanksgiving Table centerpiece.
DIY fall wreath ideas
Resources for this project:
See all materials
Comments
Join the conversation
-
Wonderful idea!
The possibilities are endless 😃
Frequently asked questions
Have a question about this project?