How do you cut a hole in glass?
Related Discussions
Blackout curtains behind vertical blinds
I have two 6' patio doors, and I want to add blackout curtains to keep the sun/cold out. What is the best way to hang them, and what can I use to push the curtains ba... See more
How to make a balloon garland?
Does anyone know how to make a balloon garland or a balloon arch?
How do I cut a hole out of the bottom of a glass wine bottle?
Once you cut a glass bottle how you remove the sharp edge ?
I had that perfect cut , but I don't know how to get ride of the sharp rim
How do you cut plexiglass without it cracking and breaking?
I need a clean smooth cut to use in a frame. It's even more expensive than glass, so need some foolproof advice.
How do I cut off the glass decanters' bottoms?
Okay, I've collected the wine decanters, I have the wiring, the sockets and the canopies; the only thing I can't figure out is how to cut off the bottoms of the decan... See more
Lay out your glass on a sturdy table and use the ruler to measure across the glass.
Get out your packing tape and cover both sides of the glass in the area you will be cutting.
Generously rub the bar of soap over the glass. Be sure you are using a brand new bar of soap as opposed to a used one.
The bar of soap will help to reduce friction that will be made between the cutting tool and the glass.
Use the dremel tool delicately to begin cutting the glass.
The glass and dremel will begin to heat. When this happens, poor a small amount of the cool water over the glass to let it cool. Once cool, you can begin cutting again.
Once the cut is finished, remove the packing tape and use the 150 grit sandpaper to refine the rough edges of the glass. Spray liberally with Windex and wipe the surface clean on both sides to finish.
Round hole? buy glass cutting drill bit;square? use glass cutter, tape it off first so it breaks out evenly.
The make special drill bits for glass. Check with your local hardware store.
Take your glass to a glass shop,,,, one hole should not be expensive and you'll only need one piece of glass,,, DIY and buy a supply of glass plus expensive bits,,,, pro's are best