Cedar Plank Recessed Coat Closet

2 Materials
$50
4 Hours
Medium
We live in a mobile home, without an area to hang our jackets, so we built a recessed area behind the door.
This is the wall I cut into.
I knew it wasn't a load bearing wall, and there wasn't any electrical wires running through it. Using a jig saw, I cut a large square so I could see into the wall. There was a stud a few inches on both ends of the wall, and one in the middle (16 inches apart).
Sorry. I didn't take a picture before I cut the stud out. I used a reciprocal saw to cut as high as the top of the door, and down to about 10 inches from the floor. (There was an old gas connection in the wall). I cut the stud board out of the middle of the wall and put a footer and header board to give it a good finished look. I used cedar planks to line the back and sides.
Using a Miter Saw, I made a frame to finish it out, using the same type planks, cut to fit.
I screwed a board the length of the cabinet about 5 feet from the floor, then used one of the cedar planks to camouflage the board. I screwed 4 double garment hooks equally spaced.
Here is the finished project. Not shown, I added another board with hooks above the hanging board, so my husband can hang his caps above the jackets. You could also store your umbrella, walking sticks, etc. on the sides, and/or put a few cup-type hooks on the side frame to put your gloves.
With this recessed closet, we can hang our jackets, and not impede the door staying open!
We love it, and it was very easy to build!

Resources for this project:

3.5 inch by 8 foot natural cedar wood tongue and groove planks
Any price and availability information displayed on [relevant Amazon Site(s), as applicable] at the time of purchase will apply to the purchase of this product.
Hometalk may collect a small share of sales from the links on this page.More info

Frequently asked questions

Have a question about this project?

  2 questions
  • Laura Laura on Jun 13, 2018

    How did you get the stud out. It always is difficult to do

  • Jim Jim on Jun 20, 2018

    about the cedar boards used to line the back . . .

    How thick were they ?

    What were they attached to ?

    How were they attached ?

Comments

Join the conversation

2 of 23 comments
Next