How do i fill these seams?

q how do i fill these seams
  7 answers
  • GrandmasHouseDIY GrandmasHouseDIY on Dec 27, 2017
    Hi Rita, get yourself some fiberglass sheet rock tape and totally cover them with that and then totally cover the tape with sheet rock mud (also know as joint compound etc.) You'll have to sand it down to get it smooth and probably do several coats.

  • Sharon Sharon on Dec 27, 2017
    Drywall taping and mudding....

  • Seth Seth on Dec 27, 2017
    How are you going to finish this drywall? Do you just want to paint it? If you cover it with thin plywood, paneling, or tongue and groove boards, you do not need to do anything else to the drywall, otherwise the above suggestions are the way to go.

  • Cindy Hagemann Cindy Hagemann on Dec 27, 2017
    This is drywall (Sheetrock), purchase mud and tape for drywall, and sanding blocks. Tape the seams, mud, smooth, let dry, sand, mud again, let dry, sand.

  • Joanne lueke Joanne lueke on Dec 28, 2017
    The screws need to be slightly below the surface of the drywall so when you mud over them you are filling in over the screws and after sanding they won't be exposed. Hopefully the video shows you how to the taping on the corner. Have fun!

  • Tinyshoes Tinyshoes on Dec 29, 2017
    Sheetrock finishing is required with tape and mud, then lots of sanding.

  • John Wade John Wade on Dec 30, 2017
    Tape it mud it sand it paint it if u need mor information let me know