How do i fix it?
+5
Just finished spraying my shower pan with Homax unfortunatly it came out rough and dull...did all the cleaning. But due to poor lighting I could not see how i was spraying all the time.
How do i fix the roughness and dull finish?
Thank you
Related Discussions
Suggested Project Book
I would try another coat after some light sanding. Sometimes all it takes is a little more time and application.
Lightly sand and apply another coat. You can use fine steel wool for the sanding. Then wipe so that you have a clean surface.
Do not use steel wool, for fear of splinters. Use a light sanding sponge. and spray another coat, it may take more than 2 so be patient
Agreed, do not use steel wool as Dee pointed out, metal splinters are no fun. A light sanding sponge should do the trick to make the surface ready for another light coat or more to do the job.
lightly sand and apply another coat.
Hi! I read the directions on the Homax website. They recommend going over drips and sags with a clean paint brush dipped in isopropyl alcohol, then letting it dry for 3 hours before applying another coat. I don't know for sure, but if additional light was set up, you might be able to catch anything before it hardens. From the website, they also recommend very light coats. I hope you are wearing gloves, goggles and a respirator after reading the warnings and chemicals. Good luck and stay safe!
Thank you all....
Repeat thin coats, until it feels smooth.