This is my ugly sanded one.
Will a 2nd coat of epoxy fill in all the sanding scratches on my table
by Traci
I already had1 coat that was not smooth it had dips and scratches so they said sand and put a 2nd coat I haven't poured yet because now its cloudy and scratched from sanding dos thenext coat fill all that? HELP. it's a bottom shelf I can't scrap it.PLEASE the top is almost done except paint.
The top of the table it's a surprise for my mom's 833rd birthday.
3 answers
-
![Beth W]()
Beth W
on Apr 09, 2018
Depending on your results with the fine sandpaper you may need to go to steel wool. -
![Sharon]()
Sharon
on Apr 09, 2018
I usually wet sand epoxy when I've messed up with 800 = 1500 grit wet sandpaper.... https://www.youtube.com/watch?v=6oVtmJhh_Ss&t=158sDid you run a torch or heat gun over the surface after it was applied to remove the bubbles? this might have caused your "dips." Use fine tweezers if you've got a bit of dust.You may want to watch some of there videos on how to avoid imperfections.![]()
-
![Beth W]()
Beth W
on Apr 10, 2018
Good luck!
Sign Up to Answer
