Roaring sound in bathroom sink
-
Liliana Wells on Jan 06, 2015It sounds like it's a vent tube on top of the roof.Helpful Reply
-
-
Deb on Jan 06, 2015Something may be obstructing the vent tube - we had a leaf stuck in the top of ours and it was causing the same sounds - we got a PVC cap that is "screened" and put on top of the vent pipe to keep stuff from getting in.Helpful Reply
-
-
Lydia O'Lydia on Jan 06, 2015^^^what they said.Helpful Reply
-
-
Al StPierre on Jan 07, 2015Run some water in the bathtub and let it drain. We had the same problem, we do not use the shower/tub in that bathroom and found out that the drain pipe dried out hence giving you that roaring sound when the sink was used.Helpful Reply
-
-
Terry on Jan 07, 2015This is in a bathroom that is used every day. When it warms up, we will check the vent stack on the roof for obstructions.Helpful Reply
-
-
Mayfee Anang-Baffour on Jan 07, 2015We have that same noise too, but ours is just because there is heavy construction going on outside our house and whenever the guys rev their trench-digging equipment, we get the jiggles and rattling in our pipes. Listen out to see if you are having some sort of construction project going on in your area, whether near or far, then it is likely what it is. If not, then......Helpful Reply
-
Related Discussions
How to get rid of mice?
We seem to have some unwelcome Mickeys and Minnies in our house. What is the best way to get rid of them?
How to remove popcorn ceiling with asbestos?
I want to remove my popcorn ceiling, but it has asbestos in it. How do I go about this safely?
How to caulk baseboard gaps?
How do I fill gaps at baseboard, should I caulk? If so, does anyone know how to caulk baseboards?
How to fix squeaky hardwood floors?
How do I fix squeaky hardwood floors?
Why does my bathroom tub and sink sound like it's burping when I flush
This is new for us home, but built in 1959. Kitchen sink drains slow but have not heard burps.
Why is the water from only one bathroom sink smell awful?
This only happens when you first turn either the hot or cold water on, or both, and after you run the water for a little, it clears up. How can I fix this?