Which glue or sealer is safe for a Brita pitcher?

I've read you can use super glue. Personally, I'd replace it.

Here's a post that might help https://www.permabond.com/resource-center/food-grade-adhesives-equipment-filters/

I’d punt. Even if you repair it, it’s got a weak point that will likely split again.

Just replace the container.

Hello. I would personally replace it myself for aesthetic reasons alone.

However JB Weld might be considered as is is stated to be non-toxic when it’s cured.

https://www.jbweld.com/faqs

I would get a new pitcher you can find them on sale Costco has great deals on them. I am against any type of glue for drinking water items

My local Walmart has the pitchers at good prices.

https://www.walmart.com/c/ep/brita-pitchers

Hello, hope this helps you out,

https://www.wikihow.com/Fix-a-Crack-in-a-Water-Bottle

If a glue that holds together AND works - I highly doubt it's food safe. I'd recycle this and get a new one.

Costco and Sams sell the pitchers for less than a good glue. And you would have to find a food safe glue

I agree, buy a new pitcher.

Hi Lifestyles. For safety reasons I think you should replace it. We use a Britta too. We have had to replace it 2 or 3 times in the last 5 yrs. It gets a lot of use here at our house. And that means we go thru a lot of filters. We buy the economy pack of filters. We buy the pitcher and filters at Wal Mart. Good luck Lifestyles.

I don't thin you can use any glue since this is used for water and it can be unsafe

I wouldn’t risk it. Just get a new pitcher

A new pitcher is $25 and I've been thinking about the PVC pipe glue that's used on our plumbing pipes.

I would be wary of using glue on anything that comes in direct contact with food.

I think its days are numbered, but a temporary fix will require a two part epoxy glue...

Hello, epoxy will work better for this, but it just does not look very pretty.

Check thrift stores they often have and assortment of pitchers. You may get lucky and find a match