This is a photo of the recent boiler Combi unit I installed.
This boiler makes both heat for two zones of baseboard and 0ne zone of radiant heat for the house. And makes the domestic hot water for two and one half baths. Cost? $8 grand. Took two days to remove old cast iron boiler and hot water heater, mount on wall, pipe and bleed out the air. Client loves it. Cannot hear it run, is 98% efficient and is warranted for 10 years. Only draw back is they must install a water softener system as the hard water will calcify to quick in the heater area and lower its ability to heat the water in an efficient manner.
NTI Combi boiler. Top of the line. Takes up a lot of wall space to install properly. Boiler heat exchanger is only as around as a five gallon bucket and deep as about one half the height of that same bucket. 110 lbs total.
Comments
Join the conversation
2 of 13 comments
-
Good tip on possibly having to replace the heater. If I have to really crank on it I might just call it a day and wait for the tank to just go bad.
-
I am trying to replace my boiler at the moment. My husband and I have had no luck understanding different tutorials we have found online. Do you think we should just cut our losses and call a repairman? We have probably done a little damage. Ruth James | http://langleyplumbing.net/en/services.html
Frequently asked questions
Have a question about this project?